Russound SUB105 Speaker User Manual


 
4
INSTALLATION
1
2
3
4
5
6
7
Rear Panel
SPEAKER LEVEL OUT – Pass-through connectors
for main left and right speakers when speaker-
level input is used. Binding posts accept banana
plugs, spade lugs, pin connectors, and bare wire
up to 12 AWG (2.05 mm).
SPEAKER LEVEL IN – Connectors for speaker-level
signals from an amplifi er or receiver. Binding
posts accept banana plugs, spade lugs, pin con-
nectors, and bare wire up to 12 AWG (2.05 mm).
RNET A/V IN – RJ-45 connector for a balanced
stereo line-level signal via CAT-5 cable from an
RNET A/V source output or an RNET A/V Encoder.
LINE-LEVEL INPUT – RCA connectors for stereo
line-level signals from a preamplifi er or receiver.
LFE INPUT – RCA connector for a prefi ltered
low-frequency effects signal from a home theater
receiver or processor.
VOLTAGE SWITCH – Sets the amplifi er to operate
on either 120 V or 240 V. Set this switch to match
the supply mains voltage.
POWER CORD RECEPTACLE – Connector for the
supplied power cord.
1
2
3 4
5
6
7