Filter
Top Products
FINAL ASSEMBLY
1. If you haven’t done so already during painting, remove the perforated grilles from both Russound In-Wall Speakers.
Use the clamp (dog-ear) to push the grille out from the back side.
2. Center the speaker in the cut-out hole and tighten the screws until the clamps are drawn up snugly from behind,
clamping the speaker in place. Try to tighten each screw equally but do not over tighten.
3. Insert the Russound speaker grille by gently pressing it into place.
In most installations, the grilles will fit tightly without causing vibration. If any audible vibration does occur, or if your
Russound speakers are ceiling mounted, you finally get to use the contents of that mysterious packet with the black
stuff wrapped in little white papers. They are pre-cut lengths of a special damping/adhesive material. Remove the
perforated grille, unwrap four of the damping strips and affix them to the four outer corners of the inner speaker
surface. Then replace the grille.
A QUICK LISTENING TEST
It’s a good idea to test everything at this point. Also, although we’ve paid close attention to speaker polarity, we hope
you labeled your wires to identify the left and right speakers.
1. Turn on your stereo system. Make sure that the VOLUME control is turned down
and that the BALANCE control is set to center.
2. Activate a musical source such as FM or CD player.
3. Gently turn up the volume. You should hear music coming out of your new Russound In-Wall Speakers! (If you
don’t, refer to the troubleshooting guide below.)
4. Now rotate the stereo’s BALANCE control all the way to the LEFT. Sound should only come out of your left in-wall
speaker. If it comes out of the RIGHT speaker, skip to Step 6.
5. Rotate the BALANCE control all the way to the RIGHT. Sound should only come out of the right speaker.
6. If sound comes from the right speaker when the stereo’s balance control is turned to the LEFT, you’ll need to
change the connections on the back of the amplifier/receiver.
* FIRST TURN OFF THE AMPLIFIER!
* Swap the wires attached to the left and right speaker terminals.
A QUICK TROUBLESHOOTING GUIDE
Before returning your Russound In-Wall Speakers for service, it is a good idea to check out these simple remedies first.
No sound from either speaker
1. Incorrect source selected on receiver or preamplifier.
2. Mute button pressed on receiver.
3. Wrong speaker output selected; many receivers have an “A” and “B” speaker switch. Make sure it’s in the right
position.
4. In-Wall Volume control not turned up or wired incorrectly.
5. If using a “speaker selector”, room/station not turned on or improperly connected
No sound from one speaker
1. Un-secure connection at either the speaker or amplifier-double-check them.
2. Balance control turned all the way left or right-return it to center.
3. Bad connecting cable between sound source and amplifier - try a new cable.
8