Filter
Top Products
15
Source
DVD CABLE
XM1 AM/FM
INSTALLER
COMPONENT GUIDE
Keypad Front Panel
1
The update jumper for the KP4 (and KPL) is located on the right side of the keypad when facing front.
This is covered when a trim plate is installed.
Note: The update pins on the KP4 are accessed from
the side when the keypad is not installed.
OS UPDATE/RUN JUMPER -The pins are
jumpered when performing a firmware
update on the keypad, and removed
during normal operation.
OS UPDATE PORT - Used to update the
KP4 and KPL keypad operating system
firmware. If an update is released, it will
be available online through the
Document Center on
www.russound.com
. Look in the
“Firmware and Downloads” section under
Multi-Zone product type. The Advanced
Programming Cable is available from
Russound, Part #2500-521065.
1
2
KP4 Front View
2
KP4 Top View
2
KP4 Side View
1
Jumpered
pins