Filter
Top Products
Installation
Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual 29
PRE
L
IMINAR
Y
3.7
Connections to the
SC-50d/SC-60d and
DHD Controller
Proceed as follows to connect the DHD Controller to the SC-50d/SC-60d, your video
sources, external controller(s) – if present – and AC power.
When connecting your equipment:
• Turn off all equipment before making any connections.
• Use the correct signal cables for each source.
• For best performance and to minimize cable clutter, use high-quality cables that are
only as long as necessary to connect two devices. (Don’t use a 20-foot cable when a
6-foot cable will suffice.)
• Ensure that the cables are securely connected. Tighten the thumbscrews on
connectors that have them.
Connecting the DHD
Controller to the
SC-50d/SC-60d
Digital Video Connection: Connect the “HDMI Out To Display” connector on the DHD
Controller to the DVI-I input in Slot 2 of the SC-50d/SC-60d as shown in Figure 3-9.
Figure 3-9. Connecting the SC-50d/SC-60d to the DHD Controller
PWR
1 - Dual Link DVI-I
2 - VGA
Signal
Digital
Analog
PWR
1 - Dual Link DVI-I
2 - VGA
Signal
Digital
Analog
Ethernet RS232 IN
Reset
Wired Keypad
Slot 2Slot 4
PWR
1 - Dual Link DVI-I
2 - VGA
Signal
Digital
Analog
Reset
Wired Keypad
Ethernet
2 - VGA
Signal
USB
To Accessory Box
Video 1
Y
Video 2
Video 3
Pr
Pb
PC / Control
RS-232
IR
Display Control
HDMI 1
HDMI 3
HDMI 2
HDMI 4
Ethernet
HDMI Out
To Display
HDMI Out
Audio Only
Component / SCART
Y
G
Pb
B
Pr
R
Pr
R
Pb
B
Y
G
TRIGGERS
RS-232
123
H
V
HD1
HD2
HV
HDMI Out
To Display
Display
Control
RJ-11
to DB-9
Adapter
(provided)
RS-232
Communication
Cable (provided)
HDMI Cable
(not provided)
DVI-I to-HDMI
Adapter
(provided)