Filter
Top Products
11
RR-939B Remote Control
The RX-1050 includes a handheld remote
control that does far more than operate the
RX-1050. The RR-939B is a full-function pro-
grammable remote control that can operate
up to 8 audio/video components.
A separate manual, included with the remote,
gives detailed information on programming
and using the RR-939B to replace all of the
remote controls in your system. This section is
intended to provide only that information which
pertains to the use of the RR-939B to operate
the RX-1050.
NOTE
: Many functions duplicate the RX-1050
front panel controls and are listed here only
for your reference. Please refer to the previ-
ous Front Panel Controls section of this manual
if you need additional information.
Operating the RR-939B
AUDIO Button
To operate the RX-1050 with the remote, make
sure that the AUDIO mode is active by press-
ing the AUD button on the remote before you
start. If it is active, pressing command keys
on the RR-939B will cause the AUDIO button
to flash red. Once the AUDIO mode is active,
it will stay active unless you press one of the
other DEVICE buttons to control a different
component.
Programming the RR-939B
The RR-939B is preprogrammed from the fac-
tory to operate the RX-1050. Should the AU-
DIO command set on your RR-939B not op-
erate the RX-1050, it’s possible that the pro-
gramming has been inadvertently changed.
To program the remote to operate the
RX-1050, set the AUDIO Code = 001:
1. Press the AUDIO
button at the top of
the remote while simultaneously pressing
the MUTE button and hold both for at least
one second. The AUDIO button will light
in red for 20 seconds, indicating that you
have entered the program mode. The next
step must be done within this 20 second
period, or the RR-939B will revert to its
standard operating mode.
2. Use the NUMERIC
buttons to enter the
3-digit code (001) for the RX-1050 – press
0, then 0, then 1. The AUDIO button will
flash each time you enter a digit.
3. Store the code number by pressing the cor-
responding AUDIO button again. The button
will blink twice to confirm the storage of
the code in memory.
SHIFT Button
The SHIFT button on the remote is used to ac-
cess secondary functions on several RR-939B
buttons. Press the SHIFT button and then the
desired button.
Basic Controls
POWER Button
The front-panel POWER switch on the RX-1050
is a master power control. It must be pressed
IN for the unit to operate. When it is in the
OUT position, the unit is fully off and cannot
be activated from the remote control. The
POWER switch on the remote functions as a
standby switch, activating or deactivating the
unit. In standby mode, minimal power is still
supplied to memory circuits to preserve set-
tings. When the unit has AC power applied
and the front-panel POWER button is pressed
IN, the front-panel POWER LED lights, regard-
less of whether the unit is in standby mode or
fully-activated in the main room. In normal
operation, use the STANDBY switch to deac-
tivate the unit when you are finished listening
and leave the POWER switch ON at all times.
This will preserve memory functions.
Remote Sensor
This sensor receives infrared signals from the
handheld remote control. Make sure you do
not accidentally block this sensor with cables
or accessories.
Front Panel Display
The large fluorescent display in the upper
portion of the RX-1050 provides status infor-
mation used in operating the AM/FM receiver
(such as station frequency display, band, preset
memory, etc.).
English