Filter
Top Products
8. Connect the source signal to the amplifier by plugging the RCA
cables into the input jacks at the amplifier.
9. Connect the speakers. Strip the speaker wires 5/8". Insert the bared
wire into the speaker terminal and tighten the set screw to secure
into place. Be sure to maintain proper speaker polarity.
DO NOT
chassis ground any of the speaker leads as unstable operation
may result.
10. Perform a final check of the completed system wiring to ensure
that all connections are accurate. Check all power and ground
connections for frayed wires and loose connections which could
cause problems.
11. After the final inspection is complete, install the power fuse and
enjoy listening. During the initial listening period, you may need
to “fine tune” any phasing and level settings within your particular
vehicle. To aid in this procedure, play a track with high musical
content and cruise around your neighborhood. After fully evalu-
ating the transient response of your system and making any final
adjustments, all your neighbors within a 1 mile radius will assume
that you have just successfully completed another upgrade to your
audio system for which they will probably spill thumbtacks on
your driveway.
– 11 –