Filter
Top Products
Dynamic Power Rating (IHF-202 Standard) - Measured at 14.4V
Mono into a 4Ω load 100 Watts
Mono into a 2Ω load 200 Watts
Mono into a 1Ω load 325 Watts
2-channel Bridged (using 2 Punch 50.1) into a 2Ω load 650 Watts
Continuous Power Rating (Competition Standard) – Measured at 13.8 Volts
RMS continuous power mono, into a 4Ω load from 20-20,000Hz
with less than 0.05% THD 50 Watts
RMS continuous power mono, into a 2Ω load from 20-20,000Hz
with less than 0.10% THD 100 Watts
RMS continuous power mono, into a 1Ω load from 20-20,000Hz
with less than 0.3% THD 200 Watts
RMS continuous power bridged, (using 2 Punch 50.1
Power amplifiers in the same system) into a 2Ω load
from 20-20,000Hz with less than 0.3% THD 400 Watts
Signal-to-Noise Ratio: >100dB (A-weighted)
Frequency Response: 20Hz-20,000Hz ±0.5dB
Bandwidth: 10Hz–250kHz ±3dB
Damping Factor @ 4Ω (at output connector): >200
Slew Rate: 50V ms
IM Distortion (IHF): <0.05%
Input Impedance: 20k Ohms
Source Unit Compatiblity (+15dB gain overlap): 28V max. input
Input Sensitivity (+0dB gain overlap): Variable from 300mV to 5V
Pass-Thru Output: Unity Gain
B+ Fuse Size: (External to amplifier) 40 Amp or two 20 Amp
Fuse Type: AGU
Crossover Slope: 12dB or 24dB/octave Butterworth
Factory Crossover Frequency: 80Hz (0.047mf)
Factory Default Crossover Setting: Full Range
Dimensions: 9-5/8"W x 13-9/32"L x 2-5/8"H
(24.4cm) x (33.73cm) x (6.6cm)
50.1 S
PECIFICATIONS
– 47 –
Specifications subject to change without notice.