Filter
Top Products
250.1 S
PECIFICATIONS
– 47 –
Dynamic Power Rating (IHF-202 Standard) - Measured at 14.4V
Mono into a 4Ω load 420 Watts
Mono into a 2Ω load 710 Watts
Bridged (using 2 Punch 250m) into a 4Ω load 1420 Watts*
Continuous Power Rating (Competition Standard) – Measured at 13.8 Volts
RMS continuous power mono, into a 4Ω load from 20-20,000Hz
with less than 0.10% THD 250 Watts
RMS continuous power mono, into a 2Ω load from 20-20,000Hz
with less than 0.15% THD 500 Watts
RMS continuous power bridged, (using 2 Punch 250.1
Power amplifiers in the same system) into a 4Ω load
from 20-20,000Hz with less than 0.15% THD 1000 Watts
Signal-to-Noise Ratio: >100dB (A-weighted)
Frequency Response: 20Hz-20,000Hz ±0.5dB
Bandwidth: 10Hz–250kHz ±3dB
Damping Factor @ 4Ω (at output connector): >200
Slew Rate: 50V ms
IM Distortion (IHF): <0.05%
Input Impedance: 20k Ohms
Source Unit Compatibility (+15dB Gain Overlap): 28V max. input
Input Sensitivity (+0dB Gain Overlap): Variable from 300mV to 5V
Pass-Thru Output: Unity Gain
B+ Fuse Size: (External to amplifier) 60 Amp or two 30 Amp
Fuse Type: AGU / Maxi Fuse
Crossover Slope: 12dB or 24dB/octave Butterworth
Factory Crossover Frequency: 80Hz (0.047mf)
Factory Default Crossover Setting: Full Range
Dimensions: 9-5/8"W x 14-9/32"L x 2-5/8"H
(24.4cm) x (36.27cm) x (6.6cm)
*This is the calculated Dynamic Power Rating. Actual output power exceeded the input capability of the PowerCube.
Specifications subject to change without notice.