Filter
Top Products
If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
4
Controls
(Left side) (Right side)
19. Handle
20. Mains power socket
19
20
21
22
21. DAB / FM switch
22. Battery compartment
Aerial assembly
1. Before using your radio, screw the telescopic aerial on to the protruding aerial stud by
rotating the body of the aerial in a clockwise direction (as viewed from above). Only
rotate the aerial by hand. Do not use pliers or any other tools as this may damage
the aerial.
2. When it is fully screwed in place, pull the body of the aerial upwards slightly to lift the
aerial stud and reveal its hinge. Then lay the aerial fl at and rotate it further to tighten
it fully. The hinge will also allow the aerial to be positioned at an angle or collapsed
and laid fl at when not in use.
3. For best radio reception the aerial should be restored to a vertical orientation and
fully extended.
4. The aerial may be removed for storage if necessary by collapsing the aerial and then
rotating the aerial body in an anti-clockwise direction (as viewed from above).