Filter
Top Products
8
Hint: Fixed-level audio outputs from stereo receivers/amps will typically be desig-
nated as Tape, Tape 1, and Tape 2 outputs, DAT (digital audio tape) outputs, VCR
audio output connections, and auxiliary audio outputs. Tape, Tape 1, Tape 2 and
DAT outputs are usually marked as ‘TAPE OUTPUT,’ ‘TAPE OUT,’ ‘TAPE REC,’ or
‘TAPE RECORD.’ Jacks designated for phono, CD, LD, DVD or tape playback (PB)
are inputs and will not work for purposes of installing the transmitter.
Fixed-level outputs from TVs are usually marked as ‘Constant,’ ‘Fixed,’ or ‘Select.’
If they are not marked as such, they are probably variable outputs (see “About
Variable-Level Outputs” below).
Outputs from VCRs are almost always fixed.
Hint: When connecting to the fixed audio outputs of a VCR, remember that for the
wireless system to work, the VCR must be active. In other words, turn the TV on to
the channel you would normally use to watch a videotape (channel 3 or 4), turn the
VCR on, then press the TV/VCR button on your VCR remote control one time to
make the VCR the controlling piece of equipment. At this point, whatever channel is
showing on the tuner for the VCR should be the channel playing on the TV. Change
channels on the VCR. This configuration gives independent volume control through
the TV (using the TV remote control) and at the speakers.
Hint: If your VCR (or other RCA-type audio source you are connecting to) is mono (a
single audio output), you need to acquire another RCA “Y” Cable. It differs from the
“Y” Cable Adapter included in this kit. It will have a single male RCA plug and 2
female RCA jacks. Connect the dual RCA plugs from the “Y” Cable Adapter (Q) to
the 2 female RCA jacks on the second “Y” cable, then connect the single male RCA
plug of the second “Y” cable to the single audio output of the VCR.
About Variable-Level Outputs
A variable-level output, such as a headphone jack or certain RCA-type outputs, pro-
vides an audio signal to the transmitter that changes in relation to volume level on the
audio source. As the volume of the audio source goes up and down, so too does the
audio signal strength sent to the transmitter. This can affect the quality of sound you
hear at the speakers, and may require increasing or decreasing the volume level of the
audio source to achieve a suitably strong audio signal for use with the AW820 system.
Hint: On most bookshelf-type or compact stereo systems, inserting a headphone
plug into the headphone jack results in automatic cutoff of the regular, or hard-
wired, speakers.