Filter
Top Products
39
Appendix A: Connecting the Receiver
L/MONO
RIGHT
AUDIO
RECEIVER
IN OUT
IN OUT
IN OUT
(MONO)
1
2
VIDEO
SUB WOOFER
OUT
AUDIO
SOURCE
VCR 2/
LD
MONITOR
OUT
CD TAPE/MDTV
VCR 1 DSS
VCR 2/
LD
VCR 1 DSS
AUDIO
AUDIO
L
R
L
R
L/MONO RIGHT
S-VIDEO
INPUT 1
VIDEO
L/MONO RIGHT
S-VIDEO
INPUT 2
VIDEO
L/MONO RIGHT
INPUT 3
VIDEO
ANT A
SIGNAL
SOURCE
L/MONO RIGHT
OUTPUT
BRIDGED
FROM
INPUT 1
VIDEO
L/MONO RIGHTVIDEO
VIDEO
FIXED
OUTPUT
TV TUNER
OUTPUT
TV
CABLE
BOX
IN
OUT
OR ANTENNA
VCR
OUT TO TV
CH3
CH4
LR
IN FROM ANT
VIDEO
ANT B
IN
OUT
TV and VCR
This connection provides
• stereo or surround sound from TV programs
broadcast in stereo
• stereo, surround sound or mono sound from a VCR
• viewing one channel on TV while recording another
channel
To use this connection, you
Should have
• (3) paired (red/white) stereo cables
• (3) single (yellow) video cables
• (2) coaxial cables
To Connect
1. Connect the cables as shown in the
diagram below.
Using This Connection
To watch TV programs
1. Turn off the VCR.
2. Press TV and tune to a channel.
To watch or play a tape on the VCR
1. Press VCR1.
2. Press PLAY.
To record one program and watch another
1. Press VCR1 and tune to a channel.
2. Begin recording.
3. Make sure TV/VCR switch on the
VCR is set to TV.
4. Press TV and tune to a channel.
If your TV has more than one video
input, make sure the VCR1, VCR2 and
DSS buttons tune the TV to the same
channel that the receiver monitor
out is plugged into.
Refer to the TV’s user’s guide for
more information.