RCA RT2280 Stereo Receiver User Manual


 
Getting Started
Unpacking The Speakers (RT2280/RT2250 Only)
• one set of speakers including 2 left and right front
speakers, 1 centre speaker, 1 subwoofer and 2 left
and right rear speakers.
• 6 speaker cables including:
Inserting Batteries into Remote Control
Insert two AA(R6) batteries according to the + and -
signs on the battery compartment. To use the remote
control, point it directly at your receiver.
Set up and Maintenance of the Receiver
• Provide spaces for sufficient ventilation as
indicated:
• Do not connect to the AC power cords until all
connections are completed.
• Do not use your set immediately after transferring
it from a cold place to a warm place: there is risk of
condensation.
• Do not expose your set to water and excessively
high temperatures.
• After having disconnected your set, clean the case
with a soft cloth, or with a slightly damp leather
chamois. Never use strong solvents.
Protect your Components from
Overheating
• Do not block ventilation holes in any component.
Arrange the components so that air can circulate
freely.
• Do not stack components directly on top of each
other.
• Allow adequate ventilation when placing your
components in a stand.
• Place an amplifier near the top shelf of the stand
so heated air rising from it will not affect other com-
ponents. If you have a satellite receiver, you should
place it on the top shelf.
EN
3
10 cm/4"
10 cm/
4"
10 cm/
4"
10 cm/4"
5 cm/
2"
FRONT SPEAKERS
CENTER SPEAKERS
SUB WOOFER
REAR SPEAKERS
(SURROUND SOUND)
2 X grey/black cable
for rear speakers
1 X brown/black
cable for subwoofer
1 X blue/black cable
for centre speaker
2 X red/black cable
for front speakers