Filter
Top Products
EN
21
Advanced Sound Control
Fine Setting of the Speakers
This receiver supports a wide range of speakers and
subwoofers. For optimal surround sound enjoyment,
you need to register the speaker selection settings of
your audio system. If you buy this receiver with
accompanied speaker package, then this step has
been done for you.
Also, to make the surround sound more effective and
suit the acoustic conditions in your listening room,
you need to delay the signal from some of the speak-
ers. Such channel delay compensates for center or
surround speakers that are closer to listening position
than the front speakers. You can make use of the
TEST/ SET UP button to adjust the speakers’ relative
loudness.
The TEST/ SET UP button
You can adjust the relative loudness of the individual
speakers by TEST/ SET UP button. In Dolby modes,
press the button briefly. A short noise will be heard
in the speakers one by one. The speaker having the
noise at that moment will be shown in the display.
You can listen to that speaker and rotate the MULTI
JOG to adjust the level.
Advanced Setting
Factory defaulted Advance setting indication
from VFD
The receiver has defaulted the following distances:
Front speakers (L/R) 15 ft
Center speaker (Cch) 15 ft
Rear speaker (SUR) 10 ft
Speaker Configurations
You can also change the setup of the speakers by
pressing the TEST/ SET UP button until the display
shows L/R SML or L/R LRG which enables you to set
the size of the front speaker.
Available Selections:
Pressing TEST/SETUP repeatedly while the display is
still showing L/R LRG (about 5 seconds), the display
will toggle among: front, center, surround, sub-
woofer, subwoofer phase and speakers’ distance
setup. Set the speaker size or speakers’ distance by
rotating the MULTI JOG.
SUR
SUR
L/R
C ch
L/R
Front
Left
Rear
Left
Rear
Left
Front
Left
Center
Front Speaker selection Large/ Small
Center Speaker selection Large/ Small/ None
Surround Speaker selection Large/ Small/ None
Subwoofer selection Yes/ No
Subwoofer Phase + / -
Front Speaker distance 0-40 ft
Centre Speaker distance 0-40 ft
Rear Speaker distance 0-40 ft
NOTE
• The sub-woofer selection will always be YES
when the main speakers are set to small
(SML).
• For the subwoofer phase setting, it will be
affected by how you locate the subwoofer.
Try both + and - settings and select the one
that has better bass effect.
• If your unit comes with speakers
(RT2280/2250), always set all speakers size to
“small” to protect them and optimize the
sound quality.