Filter
Top Products
To Adjust the Volume
Adjust the VOLUME levels to obtain the desired volume.
Note: Press the
MUTE button to turn off the sound and the volume numbers
will blink on the display. Press the
MUTE button again or press the VOLUME +/-
buttons to resume the voice.
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance with the manufacturer’s
instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or
other apparatus (including amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A
polarized plug has two blades with one wider than the other. A grounding type
plug has two blades and a third grounding prong. The wide blade or the third
prong are provided for your safety. If the provided plug does not fit into your
outlet, consult an electrician for replacement of the obsolete outlet.
10. Protect the power plug from being walked on or pinched particularly at plugs,
convenience receptacles, and the point where they exit from the apparatus.
11. Only use attachments/accessories specified by the manufacturer.
12. Use only with a cart, stand, tripod, bracket, or table specified
by the manufacturer, or sold with the apparatus. When a cart is
used, use caution when moving the cart/apparatus combination
to avoid injury from tip-over.
13. Unplug this apparatus during lightening storms or when unused
for a long period of time.
14. Refer all servicing to qualified service personnel. Servicing is
required when the apparatus has been damaged in any way,
such as the power-supply cord or plug is damaged, liquid has
spilled or objects have fallen into the apparatus, the apparatus has been exposed
to rain or moisture, does not operate normally, or has been dropped.
SAFETY PRECAUTIONS
IMPORTANT SAFETY INSTRUCTIONS
User Manual
It’s important to read this User Manual prior to using your new product
for the first time.
WARNING:
FCC Information
This device complies with Part 15 of the FCC rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
NOTE:
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
is connected.
WARNING: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
For Customers in Canada
interference regulations.
Warning:
The AC adapter is used as disconnect device and it should remain readily operable during
intended used. In order to disconnect the unit from the mains completely, the AC adapter
should be disconnected from the mains socket outlet completely.
intended use.
such as newspaper, table-cloths, curtains, etc.
.
On Safety
As the laser beam used in this compact disc player could be harmful to the eyes, do not
attempt to disassemble the casing. Refer servicing to qualified personnel only.
interlock may be defeated allowing the laser to remain on when the lid is opened.
unit checked by qualified personnel before any further operation.
On Operation
Since the CD system offers a wide dynamic range, the peaks of the high level inputs are
recorded with high fidelity, and the noise level is very low. Do not turn up the volume while
listening to a part of the disc with no audio signals or very low level inputs. If you do so, the
speakers may be damaged when the peak level of the sound is played. The lens of the laser
should be kept clean. Do not touch the lens. If you do so, the lens may be damaged and the
unit will not operate correctly.
On Use
- Heat sources such as radiators or air ducts.
- Direct sunlight.
- Excessive dust.
- Moisture or rain.
- Mechanical vibration or shock.
- Uneven surface.
etc. If you do so, the temperature inside and outside the unit may rise considerably,
resulting in malfunctioning of the unit.
room, the moisture may condense on the lens inside the unit. Should this occur, the
unit will not operate. In this case, remove the disc and leave the unit in a warm place
for several hours until the moisture evaporates.
Additional safety information
Always leave sufficient space around the product for ventilation. Do not place product in or
serviceable components.
Precautions
corresponds to the cartridge and stylus of a record player. Although this product
incorporates a laser pick-up lens, it is completely safe when operated according to directions.
dust from collecting on the pick-up lens, do not leave the compartment door open for
an extended period of time. If the lens becomes dirty, clean it with a soft brush, or use
an air blower brush designed for camera lenses.
Headset safety
unit before you put on headphones. Increase the volume to the desired level only after
headphone are in place.
volume play.
hazardous situations. Even if your headset is an open-air designed to let you to hear outside
sounds, do not turn up the volume so high that you are unable to hear what is around you.
Portable Cart
Warning
REMOTE CONTROL
GETTING START
ACCESSORIES
1. EQ / TIMER button
2.
ON/OFF button
3. RANDOM button
4. TUNING - /
button
5. MEM.UP /
button
6. MENU button
7.
MUTE button
8. VOLUME + / - buttons
9. FUNCTION button
10.
button
11. SLEEP button
12. TUNING + /
button
13. SELECT button
14.
STOP button
15.
button
16.
PLAY / PAUSE button
17. PROG / MEM /
button
(Same as MEM /
button
on the unit)
Using the Remote Control Correctly
Battery Replacement
When the battery becomes weak, the operating distance of the remote control is
greatly reduced and you will need to replace it.
Note: If the remote control is not going to be used for a long time, remove the
battery to avoid damage caused by battery leakage corrosion.
WARNING:
or equivalent type.
CAUTION: When discarding batteries, environmental problems must be considered
and local rules or laws governing the disposal of these batteries must be strictly
followed.
ATTENTION
Remove the plastic sheet
before operating the
remote control.
Please locate the included accessories.
To order replacement units, visit http://www.RCAav.com
Remote with battery ............. x 1
AC adapter ............................. x 1
1. Open the battery door.
2. Insert one CR2025 (3V) size battery.
1. Press the button to turn the unit on.
2. Press the FUNCTION button to switch to RADIO mode (only
FM band is available).
3. Press the
or button to tune in to a station.
4. Adjust the volume levels.
Searching for a Station Automatically
or button until the tuner starts searching for a station,
then release. After tuning in a station, the search stops.
Presetting Stations
The unit can store a total of 20 stations in memory. Presetting allows you to tune in
to a station directly.
1. Tune in to a desired station.
2. Press the MEM/
button. The “MEMORY” indicator and preset number and will
blink on the display.
3. Press the MEM.UP/
button if you wish to store to a different preset number.
4. Press the MEM/
button again to store it in memory.
5. Repeat steps 1-4 to store other stations.
Tuning in to a Preset Station
Press the MEM.UP/ button to select a preset station.
For Better Reception
Fully unwind the antenna wire. Extend the antenna wire and place it in the position
that sounds best.
Notes:
((STEREO))” indicator will appear on the
display.
E - 1 E - 2 E - 3 E - 4
This product contains
a low power laser
device.
The symbol for Class II
(Double Insulation)
LOCATION OF CONTROLS
1. MEM / button (Same as
PROG / MEM /
on the
remote control)
2. TUNING + /
button
TUNING - /
button
3.
PLAY/PAUSE button
STOP button
4. Remote control sensor
5.
STANDBY/ON button
6. Standby indicator
7. TIMER indicator
8. Display
9. FUNCTION button
10.
/ buttons
11. SELECT button
12. MENU button
13. MEM.UP /
button
14.
OPEN button
15. iPod dock
®
16. CD Door
17. DISPLAY button
18. VOL + / VOL - buttons
19. FM antenna
20. LINE IN jack
21. Right & Left speaker
terminals
22. DC IN jack
23. Speaker
VOLUME ADJUSTMENT
CLOCK SETTING
mode, the standby indicator illuminates.
1. Press and hold the MEM/
button until the hour digits blink.
2. Tap the
or button to adjust to the desired hours then tap
the PROG/MEM/
button once to confirm. The minute digits
will begin to blink.
3. Tap the
or button to adjust to the desired minutes then
tap the MEM/
button once to start clock.
Note:
the DISPLAY button, the current time will be shown on the
display.
LISTENING TO THE RADIO
RS3081i
CD Audio System
with rotating dock for iPhone and iPod
SYSTEM CONNECTIONS
Speaker Connections
Connect one speaker to the R terminal and the other speaker to the L terminal.
Note: Connecting speakers other than the speakers supplied with the unit may
damage the unit.
Using the AC Adapter
Using an AC adapter other than the one supplied with the unit may damage the unit.
CAUTIONS:
equipment.
from the wall outlet.
through the unit, even when the power switch is turned off.
FM ANTENNA
Do not connect the FM antenna to an outside antenna.
AC
adapter
To AC
outlet
To DC IN jack
SPEAKER
BOX
SPEAKER
BOX
FM antenna
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
UNIT - Front UNIT - Rear SPEAKER
1
13 14 15 16 17 18 19 20 21 2322
2 3 4 5 6 7 8 9
10 11 12
iPod adapter .......................... x 4