Filter
Top Products
General Controls
Main Unit - Front View
ON/STANDBY - Press briefly to turn on and off
the unit.
DEMO/DIMMER - Activates and deactivates
demonstration.
SOURCE - Selects among CD player, tuner, USB,
mp3 player and AUX.
BAND/INFO - In CD mode - Selects display
options to show track elapse time, track remain
time or disc remain time.
In mp3 / WMA mode - Shows ID3 tag.
In USB / mp3 player mode - Shows memory usage.
In Tuner mode - selects radio band.
REC USB - Starts and stops record to USB
device.
REC PORTABLE PLAYER - Starts and stops
record to mp3 player.
BACK - In navigation mode - navigates
backwards.
In rename mode - edits previous alphabet
SELECT - In mp3 / WMA / USB stop mode - Enters
navigation mode.
In navigation mode - navigates forward.
In rename mode - confirms the editing alphabet
(PLAY/PAUSE) - Starts and pauses playback
for CD, USB and mp3 player.
TUNE/PRESET - Stops CD, USB and mp3 player
In record mode - stops recording.
In Tuner mode - selects tune or preset mode.
(SKIP FORWARD) - In CD mode - Goes to
the next CD track and setting options; searches
forward through CD;
In USB and mp3 player mode - Skips to the next
file;
In Tuner mode - Tunes up radio frequency.
(SKIP BACKWARD) - In CD mode - Goes to
the previous CD track and setting options;
searches backward through CD;
In USB and mp3 player mode - Skips to the
previous file;
In Tuner mode - Tunes down radio frequency.
TUNE/PRESET
mp3 player
SOURCE
PHONES
BAND/INFO BACK SELECT
ON/
STANDBY
DEMO/DIMMER
CD-R / RW COMPATIBLE
mp3
DIGITAL MUSIC STUDIO
REC
USB
REC
PORTABLE PLAYER
RS2050
Sleep
CDCD
CD
Tips:
In STANDBY mode, press ON/STANDBY to
turn the system on in the previously used
mode. Press SOURCE to select the
corresponding mode. Look at the display icons
to identify the current mode.
Getting Started
Using the FM and AM Antennas
Before you use your audio system, you’ll want to
make sure both the FM and AM antennas are
positioned properly. Uncoil the FM antenna at
the back of the unit, making sure it is fully
extended (you may even want to tape it to the
wall behind the unit if possible. The higher the
better.) You’ll also need to connect the AM
antenna loop to the back of the unit if you listen
to AM stations. Rotate the AM loop antenna for
better reception.
Connecting the Speakers
Speaker terminal tabs marked L are for left while
R are for right. Each speaker has a black
(negative) and a red (positive) wire. When
connecting the speakers, match the red wires to
the red jacks and the black wires to the black
jacks.
Installation
To ensure sufficient ventilation, keep the spacings
shown below free from other surfaces:
TUNE/PRESET
mp3 player
SOURCE
PHONES
BAND/INFO BACK SELECT
ON/
STANDBY
DEMO/DIMMER
CD-R / RW COMPATIBLE
mp3
DIGITAL MUSIC STUDIO
REC
USB
REC
PORTABLE PLAYER
RS2050
Sleep
CDCD
CD
10 cm
10 cm
Front View
10 cm
10 cm
5 cm
Side View
Release tab to lock wire in
the terminal.
NOTE: Make sure the insulation
is completely removed from the
ends of the
speaker wires at all connection
points.
Speaker
Wire Connection
Push Speaker terminal tab
down to insert wire.
EN
EN
4
3
2050_fr_CS196 final_EN 16/1/06 5:35 PM Page 10