Filter
Top Products
8:27 S-VIDEO 90
Antenna: A
Cable/Air: Cable
VCR 1 Chan: 91
VCR 2 Chan: 92
Cable Chan: 90
3
4. Press + to enter channel 91 for VCR1 Chan.
¥Laserdisc player: Repeat the above steps, substituting VCR2 Chan and pressing 9,
then 2, for channel 92. Then press + to enter the channel.
¥Satellite Receiver: Repeat the above steps, substituting Cable Chan and pressing 9,
then 0, for channel 90. Then press + to enter the channel.
Mute
Video Menu
Audio Menu
Setup Menu
Autoprogram
Chan Mem: Stored
Antenna: A
Cable/Air: Cable
VCR 1 Chan: Off
To Set Up TV Channels for VCR, Laserdisc Player, and Satellite Receiver
To have your TV automatically turn on and tune to the proper channel for viewing the
VCR, Laserdisc player, or satellite receiver when you press the corresponding button on the
remote, set up the channels as explained below. When properly programmed the following
will happen:
¥ Pressing VCR1 on the remote will turn on the VCR, audio/video receiver, and TV, and
tune the TV to channel 91 to view the picture from the VCR.
¥ Pressing VCR2•LD on the remote will turn on the Laserdisc player, audio/video
receiver, and TV, and tune the TV to channel 92 to view the picture from the
Laserdisc player.
¥ Pressing DSS•CABLE on the remote will turn on the satellite receiver, audio/video
receiver, and TV, and tune the TV to channel 90 to view the picture from the
satellite receiver.
1. Press TV on the remote to turn on the TV and audio/video receiver. Select an active
channel on the TV. Adjust the volume, if necessary.
2. Press TV MENU on the remote until Setup Menu is highlighted. Press the + button or – on
the remote to display the setup functions, and then repeatedly press TV MENU to select
VCR1 Chan function.
3. Press 9, then 1, to tune the TV to channel 91 Ñ this is the channel to which the TV
will tune automatically when you press the VCR1 button on the remote.
8:27 Input 1 91
Autoprogram
Chan Mem: Stored
Antenna: A
Cable/Air: Cable
VCR 1 Chan: 91
Setting Up Your TV
(Continued)
Note: If you enter the wrong numbers, press the number buttons to enter the correct number.