Filter
Top Products
17
To Set Surround Modes for Each Input
1. Press the Input you want to set the surround mode for. (TV, VCR1, VCR2•LD, DSS, etc.)
2. Set the surround mode by repeatedly pressing the SURROUND button on the remote or the
SURROUND MODE button on the receiver until the surround mode you want is selected.
¥ If the receiver does not toggle through the surround modes when you press the
SURROUND button, press the BY-PASS button and then the SURROUND button.
3. Press 1 to Begin setup. Just follow the directions on the screen.
¥ Once the surround mode has been selected, the receiver will always go to that surround
mode when that input is selected.
Use this method to set up all inputs.
Using Your Audio/Video Receiver