Filter
Top Products
6
Installing the Speaker
1. Determine where each speaker cabinet will need
to be installed.
2. If the cabinet is installed in a vertical position,
the terminal cup will need to be on the top
(see figure 1).
3. Position and brace the speaker cabinet in-
between two studs by using a couple of
screws to hold the speaker in place
(see figure 2).
NOTE: The front of the cabinet should be flush
with the front of the studs.
4. Using the included wood screws, secure both
sides of the speaker as shown in figure 3.
Use a minimum of three screws per side to
secure the cabinet.
OPTIONAL: Use construction adhesive between
the speaker cabinet and studs to secure the
speaker in place.
6. Connect speaker wire to the terminal plate.
7. If the cardboard debris shield was removed
during the process of installing the speaker
wire, replace it (see figure 4).
8. With the speaker wire ran and the cabinet
secured between the studs the drywall can
now be installed.
IMPORTANT: To avoid vibrations between the
drywall and the speaker cabinet use construction
adhesive and adhere the drywall to the speaker
cabinet and studs for stability.
Left Rear
Left Surround
Figure 1
Figure 2
Figure 3
Figure 4