Ramsey Electronics FR6 Radio User Manual


 
FR6 7
4 62 pF (C3,4,9,10)
4 100 pF [marked 100, 101, or 101K] (C6,11,12,22)
1 220 pF [marked 220 or 221] (C18)
6 .001 uF [marked .001 or 102 or 1 nF] (C7,8,20,23,24,25)
8 .01 uF [marked .01 or 103 or 10 nF] (C13,16,17,21,26,28,29,31)
1 .1 uF [marked .1 or 104] (C34)
1 1.0 uF electrolytic (C27)
3 4.7 or 10 uF electrolytic (C15,30,36)
4 100 to 220 uF electrolytic (C14,32,33,35)
Controls and Hardware
1 Printed circuit board
3 10K ohm potentiometer (R1,R2,R3)
1 DPDT push switch (S1)
1 PC mount RCA jack (J1)
1 PC mount subminiature speaker jack (J2)
1 9-volt battery bracket
1 9-volt battery snap-on clip
REQUIRED, NOT SUPPLIED
1 9-volt alkaline battery
1 VHF antenna with cable terminated in RCA-style plug or adapter
1 Speaker or headphones
NOTE CONCERNING THE AUDIO OUTPUT JACK
Your receiver kit is supplied with a standard subminiature 2.5 mm (3/32")
audio output jack, which mates with commonly available earphone plugs and
adapters available at Radio Shack, such as 274-290 (plug) or 274-327
(adapter for 1/8" mono plug). If you prefer to use another size and style jack,
we suggest that you still install the original jack and then wire your own jack in
parallel with it rather to rough up the PC board to accommodate your jack.