Filter
Top Products
DA25 • 16
INSTALLATION OF THE ANTENNA MOUNT
When you are satisfied that your solder connections are “just right”, we will
install the PVC antenna mast coupler included with the kit. The mast mounting
is a 1” PVC coupler. We recommend that you glue the coupling into place with
some RTV or contact cement. Be sure to fit the coupler firmly into place after
threading the cable assembly through it. If the glue sets up with the coupling in
a little tilted, you will forever see a slightly “off balance” discone.
IMPORTANT NOTE CONCERNING OUTDOOR USAGE
Many of the metal components contained in your discone antenna will oxidize
and rust if left exposed to direct weather. It is recommended that if you are
planning on permanently mounting the antenna outdoors you coat the entire
unit with an enamel paint before installing.
Glue Here