Filter
Top Products
6
1. Insert the
supplied
adapter’s
barrel
plug into
the
DC 6V
500mA
jack on the back of the radio.
2. Route the adapter cord into the
groove on the back of the radio.
3. Plug the adapter into a standard
AC outlet.
4. Raise the antenna to a vertical
position.
MOUNTING ON A WALL
1. Drill two holes 2
3
/4-inches apart.
Then thread a screw into each
hole, letting the screw heads
extend about
1
/8-inch from the
wall. Ô
(Continued)Ifyou
cannot eliminate the
interference, the FCC
requires that you stop
using your radio.
This device complies
withPart15oftheFCC
Rules. Operation is
subject to the following
two conditions: (1) this
device may not cause
harmful interference,
and (2) this device must
accept any interference
received, including
interference that may
cause undesired
operation.
Ô NOTE Ô
To mount the radio on a
wall, you need two
screws (not supplied,
available at your local
RadioShack store) with
heads that fit the
keyhole slots on the
bottom of the radio.
2
3
/4-in
Strain
Relief
Groove