Filter
Top Products
LOW CAPACITANCE SHIELDED WIRE
GROUND
SCREW
EQ OR MIXER
3 – PYLE PRO PT-1201X/1601X/2001X/4001X Amplifier Owner’s Manual
INSTALLATION GUIDELINES
Connecting the GND (GROUND) screw terminal Connecting
a mixer or preamplifier may cause excessive noise or hum
in the amplifier output. To prevent this, connect one end
of a low-capacitance shield wire to the amplifier's ground
screw (on the rear panel). Then connect the other end of
this wire to the ground terminal on the mixer or preamplifier
enclosure.
PREAMP OR MIXER
LOW CAPACITANCE SHIELD WIRE
GROUND SCREW
Input connections
These amplifiers accept a board range of input sources,
including Compact Disc (CD,DVD) players; Cassette, Reel-
to-Reel or other tape players; Radio Tuners; Equalizers;
Signal Processors.
Connecting a CD, DVD, tape player or tuner
In a normal installation, one would use the RCA JACKS for
connecting a CD player, DVD player,tape player or tuner.
Connecting an equalizer or external signal processor
Connect the processor's OUT to the amplifier's IN connector.
PREAMP OR MIXER
LOW CAPACITANCE SHIELD WIRE
GROUND SCREW
REAR PANEL, PT-1201X
Fan Cooling
Cooling system is automatically activated whenever amplifier is turned on.
This forced air cooling system rapidly exhausts interior heat, reducing operating
temperature and aiding performance.
Stereo/Mono Switch
Lets you select conventional
stereo operation with a stereo
input signal or bridged/
mono input mode.
Input Jacks
Let you connect a variety of audio
input sources via the balanced
(XLR/6.35mm phone jack
combinations) or unbalanced (RCA)
inputs.
REAR PANEL, PT-1601X/2001X
Stereo/Mono Switch
Lets you select conventional
stereo operation with a stereo
input signal or bridged/
mono input mode.
Input Jacks
Let you connect a variety of audio
input sources via the balanced
(XLR/6.35mm phone jack
combinations) or unbalanced (RCA)
inputs.
PYLE PRO PT-1201X/1601X/2001X/4001X Amplifier
Owner’s Manual – 2
REAR PANEL, PT-4001X
Fan Cooling
Cooling system is automatically activated
whenever amplifier is turned on. This forced
air cooling system rapidly exhausts interior
heat, reducing operating temperature and
aiding performance.
Stereo/Mono Switch
Lets you select conventional
stereo operation with a stereo
input signal or bridged
/
mono input mode.
Input Jacks
Let you connect a variety of audio
input sources via the balanced
(XLR/6.35mm phone jack
combinations) or unbalanced (RCA)
inputs.
CD PLAYER, DVD , TAPE PLAYER
OR TUNER
use RCA jacks
PREAMP OR MIXER
use XLR/6.35 mm
combo jacks
EQ OR MIXER
CD PLAYER, DVD , TAPE PLAYER
OR TUNER
EQ OR MIXER
use RCA jacks
use XLR/6.35 mm
combo jacks
EQ OR MIXER
EQ OR MIXER
use RCA jacks
use RCA jacks
use XLR/6.35 mm
combo jacks
EQ OR MIXER
CD PLAYER, DVD , TAPE PLAYER
OR TUNER
use RCA jacks
use XLR/6.35 mm
combo jacks
EQ OR MIXER
use XLR/6.35 mm
combo jacks