Filter
Top Products
Once you have determined the exact placement of your speakers and the
templates are in position on your wall or ceiling, you are ready to cut
your mounting hole:
1.) Select locations for both of your loudspeakers.
2.) Check locations for interference from studs, pipes, wiring etc.
before cutting.
3.) Use the template (supplied in packaging) to scribe the mounting
holes.
4.) Cut mounting holes.
5.) Fish wires from amplifier (leave at least two feet slack).
6.) Secure cables to the wall, ceiling or a stud with cable tie or
tape.
7.) Make sure mounting screws are extended adequately for wall
thickness, fold clamps in towards chassis and place the baffle in
the mounting hole.
8.) Tighten all three mounting screws. Clamps will rotate into place
as you tighten.
9.) Connect the speaker wires to the pigtails with wire nuts
or solder. Use electrical tape to protect connections. Connect
pigtails to loudspeaker matching amplifier positive and negative
terminals to plus(+) and minus(-) terminals
on loudspeaker.
10.) Install the loudspeaker into the baffle with 4 supplied screws.
Install the grilles.
Removal after Installation
If it should ever be necessary to remove the AB Series Loudspeaker
from the wall, you must first remove the loudspeaker from the baffle.
Loosen the mounting screws just enough to allow the dogs to rotate out
of the way of the chassis.
INSTALLING IN NEW CONSTRUCTION
A rough-in kit is available separately to facilitate installations in open
framed walls and ceilings. Instructions and suggestions are provided
with this kit.
TROUBLESHOOTING
1. No sound from speakers.
•Check all amplifier connections and connections to speakers.
•Make sure amp is connected to AC outlet and
switched on.
2. Distortion at very high listening levels.
•Listen at lower levels.
•Purchase larger amplifier.
3. Not enough bass.
•Make sure speakers are in phase.
TECHNICAL ASSISTANCE
If you have any questions or problems with your loudspeaker system,
please do not hesitate to contact your authorized Polk Audio dealer from
whom you purchased your loudspeakers. Your Polk Audio dealer has the
experience needed to pinpoint any problems that may exist and has easy
access to technical information from the Polk Audio factory. If you
need assistance or information on other Polk Audio loud-
speakers for your home or car, call 1-800-377-7655.
For more information visit our web site at http://www.polkaudio.com
INSTALLING IN EXISTING CONSTRUCTION
CLAMP WILL
ROTATE AS YOU
TIGHTEN.