Filter
Top Products
1
7
SPECIFICATIONS
200-WATTS RMS PER CHANNEL INTO 8 OHMS.
BOTH CHANNELS DRIVEN FROM 20Hz TO 20kHz AT LESS THAN 0.2% TOTAL HARMONIC
DISTORTION.
FREQUENCY RESPONSE: 20Hz to 20kHz ±0.2dB. -3dB at 5Hz and -3dB at 70kHz.
DISTORTION: Typically <0.05% THD at rated power. 0.2% THD and IM worst case prior to clipping.
4 OHM POWER: 300 Watts per channel or greater.
CURRENT OUTPUT: 40A short duration peak per channel. Fuse protected.
SLEWING: 50V/µs.
HUM & NOISE: 90dB below rated output 20Hz to 20kHz unweighted.
INPUT SENSITIVITY: 300mV RMS for rated output at 1kHz. 1.5mV RMS on Phono low gain setting.
0.75mV on Phono high gain setting.
INPUT IMPEDANCE: 47kΩ.
INPUT OVERLOAD: 5V RMS.
PHONO STAGE GAIN (PHONO INPUT TO PRE-OUT): 61dB on high gain setting, 54dB on low gain setting.
R
ATED PRE OUT LEVEL: 1.5V RMS into 47kΩ or higher. Maximum 6V RMS into 10kΩ or higher.
P
RE OUT SOURCE IMPEDANCE: Typically 1.5kΩ.
P
RE OUT MINIMUM RECOMMENDED LOAD: 47kΩ.
T
APE OUTPUT LEVEL: 190mV at 200Ω. Tape loop muting at 5V RMS input.
HEIGHT: 120mm (4 3/4")
WIDTH: 450mm (17 3/4")
DEPTH: 400mm (15 3/4")
WEIGHT: 14kg (30lbs)