Plantronics W445 Headphones User Manual


 
Plantronics Savi User Guide 16
Device Settings – Headset Tab
Options Feature Settings Default
General Mute Tone Standard/Low/Off Off
Ringtone Sound 1/Sound 2/Sound 3 Sound 2
PC Volume Standard/Low/Off Standard
System Tones Standard/Low/Off Standard
Second Inbound Call Ring Continuously/Ring Once/Ignore Ring Continuously
Device Settings – Advanced Tab
Options Feature Settings Default
Audio Protection
Anti-Startle Selected/Not selected Not selected
G616* Selected/Not selected Not selected
Audio Limiting* 80 dB/85dB/Off Off
Hours on Phone Per Day 2/4/6/8 8
Feature Set Lock
Password (required) Locked/Unlocked Unlocked
*The Audio and G616 Limiting features are supported in over-the-head mode only and are based on a typical headset and recommended acoustic coupling between the headset
and the ear. Please see Headset setup for optimal wearing position.
Anti-Startle
Anti-startle provides advanced hearing protection against sudden
loud sounds. When Anti-startle is SELECTED, the system
identies and eliminates sudden loud sounds and rapidly reduces
them to a comfortable level. When Anti-startle is NOT SELECTED,
the headset limits sound levels at 118 dBA to protect your
hearing.
G616
G616 Acoustic Limiting provides additional hearing protection
against acoustic shock. When G616 Acoustic Limiting is
SELECTED, the system provides additional acoustic shock
protection. Sound levels are limited to 102 dBA as recommended
in the G616:2006 guideline issued by the Australian
Communications Industry Forum (ACIF). When G616 Audio-
Limiting is NOT SELECTED, the headset limits sound levels at
118 dBA to protect your hearing.
To change the PC Audio Bandwidth default in the software, go
to: Start > Programs > Plantronics > Plantronics Control Panel
> Device Settings – USB adapter. You also can toggle between
narrowband and wideband audio by doing a short press (less
than one second) followed by a long press (more than three
seconds) on the USB adapter subscription button while it is in an
idle state. The USB adapter light will ash red for four seconds
upon entering narrowband mode and ash green for four seconds
upon entering wideband mode. When switching between
narrowband and wideband audio, you must re-establish the audio
link for the changes to take effect.
Feature Set Lock
See the Device Settings – Security Tab for more information.