Filter
Top Products
Additional information
13
73
En
English
Français
Deutsch
Nederlands
Italiano
Español
DVD/CD/Video CD player
Sound Demo
shows in
the display and the unit
can’t be controlled.
• Press and hold
(stop) on the front panel for about five seconds. The disc
tray ejects automatically to indicate the Sound Demo mode is disabled.
Timer indicator is
blinking and the
system will not switch
on.
• Unplug the unit, then plug back in. Wait for one minute then switch on.
• Make sure the fan at the rear of the unit is not being blocked.
• Check that the speakers are connected correctly.
• Make sure the voltage of the mains power source is correct for the model.
• If the problem persists, take it to your nearest Pioneer
authorized service center or your dealer for servicing.
Problem
Remedy
Problem Remedy
The disc is ejected
automatically after
loading.
• Clean the disc.
• Align the disc properly in the disc guide.
• If the region number on a DVD-video disc does not match the number on
the player, the disc cannot be used (see
DVD Video regions
on page 67).
• The system Parental Lock level is set to a level lower than the disc you are
trying to play. See
Parental Lock
on page 57 to change it.
• Allow time for any condensation inside the player to evaporate. Avoid using
the player near an air-conditioning unit.
Playback is not
possible.
• If the disc is loaded upside down, reload the disc with the label side face
up.
Picture playback stops
and the operation
buttons cannot be
used.
• Press
(stop), then
(play) to start playback again.
• Switch the power off once, then on again using the front panel
STANDBY/ON
button.
Settings are canceled. • When the power is cut due to power failure or by unplugging the power
cable, settings will be canceled.
No picture/No color. • Check that connections are correct and that plugs are inserted fully.
• Check the instruction manual of the TV/monitor to make sure the TV/
monitor settings are incorrect.
Screen is stretched or
aspect does not
change.
• The
TV Screen
setting is incorrect. Set the TV Screen option to match the
TV/monitor you're using (see
Video Output settings
on page 55).
When recorded on a
VCR or passed through
an AV selector, there is
disturbance in the
playback picture.
• This system uses copy-protection technology which may prevent recording
or cause picture problems when connected through a VCR or AV selector.
This is not a malfunction.
XV-DV525.book 73 ページ ２００４年２月１８日 水曜日 午後２時２９分