Filter
Top Products
Additional information15
48
En
Chapter 15
Additional information
Optional system settings
These settings are accessed by using the
System Setup menu while in standby.
1 Switch the system into standby.
2 Press
SYSTEM SETUP
(
SHIFT
+
HOME
MENU
).
3 Use
/
(cursor left/right) to choose the
setting then press
ENTER
.
The current setting is shown for each option as
you cycle through the display. See below for a
full list and description of each.
4 Use
/
(cursor up/down) to adjust the
setting then press
ENTER
to confirm.
5 Repeat steps 2 to 4 to make other
settings.
System Setup menu options in standby
Below are all the available settings in the setup
menu. The first setting in each is the default.
System demo setting
Switches the automatic demo feature on or off
1
(this starts when you plug in for the first time):
•
DEMO ON
– Switches the demo feature on.
•
DEMO OFF
– Switches the demo feature off.
Key lock setting
The Key Lock feature is useful when you’ve set
the wake-up timer and don’t want the system
switched on before it activates.
•
LOCK ON
– Makes the front panel buttons
and controls inoperative.
•
LOCK OFF
– Restores regular use of the
front panel buttons and controls.
Clock format setting
Specifies how the clock is displayed:
•
12-HOUR
– Display shows 12-hour format.
•
24-HOUR
– Display shows 24-hour format.
Line attenuator setting
If the source connected to the analog
LINE
input is distorting, the attenuator will reduce
the signal level.
•
ATT 6DB
– Reduces signal level by 6dB.
•
ATT 10DB
(EV700/1000 only)
– Reduces
signal level by 10dB.
•
ATT OFF
– No attenuation
Tape deck beat cut setting
Recording AM broadcasts on cassette tape
can result in noisy recordings. If you
experience this, change the beat cut mode.
•
B.CUT 1
•
B.CUT 2
Frequency step setting
If you find that you can’t tune into stations
successfully, the frequency step may not be
suitable for your country/region.
• AM 9K
– AM 9kHz / FM50Hz
•
AM 10K
– AM10kHz / FM100Hz
Note
1 After setting the clock, the demo mode switches off automatically. However, if you unplug the system from the wall outlet, the
demo mode will revert to
DEMO ON
(and the clock will be reset).
EV-500-1000.book 48 ページ ２００５年４月５日 火曜日 午後１２時３１分