Pioneer XV-EV700 Cassette Player User Manual


 
Setting up for surround sound
05
23
En
English
Français
Deutsch
Nederlands
Italiano
Español
Chapter 5
Setting up for surround sound
EV700/1000 model only
Home theater sound setup
Depending on the size and characteristics of
your room, you can place your speakers in one
of two ways using this system:
1
Standard surround 5-spot setup
– This is
a standard multichannel surround sound
speaker setup for optimal 5.1 channel
home theater sound.
Front surround 3-spot setup
– This setup
is ideal when rear surround speaker
placement isn't possible or you want to
avoid running long speaker cables in your
listening area. Use this setup together with
the Front Surround modes to take
advantage of wall and ceiling reflections
for a very realistic surround effect.
After placing your speakers, complete
Setting
the channel levels
then refer to
Speaker
distance setting
on the next page to complete
your surround sound setup.
Setting the channel levels
Set the relative channel levels from your main
listening position.
2
1 Press
TEST TONE
(
SHIFT
+7).
The test tone is output in the following order
(from the speakers active in the current
listening mode):
L
– Front left speaker
C
– Center speaker
R
– Front right speaker
RS
– Surround right speaker
LS
– Surround left speaker
SW
– Subwoofer
3
2 Use the VOLUME +/– button to adjust
the volume to an appropriate level.
3 Use the
/
buttons to adjust the
speaker levels in turn.
You should hear the test tone at the same
volume from each speaker when seated in the
main listening position. The channel level
range is ± 10 dB.
4 When you’re done, press TEST TONE to
exit test tone setup.
Note
1 See
About the listening modes
on page 25 for more on using the different listening modes with each speaker setup.
Front left
Surround
left
Listening position
Center
Subwoofer
Front right
Surround
right
Front
left
Front
right
Surround
left
Surround
right
Listening position
Center
Subwoofer
2• Make sure headphones are unplugged.
• The channel balance can be adjusted (independently for each listening mode) while listening to any sound source you want:
Press
CH LEVEL
(
SHIFT
+
8
) then use
/
to select channels and
/
to adjust the level. Press
ENTER
when you’re finished.
3 Since the subwoofer produces ultra-low frequencies its sound may seem quieter than it actually is.
EV-500-1000.book 23 ページ 2005年4月5日 火曜日 午後12時31分