Filter
Top Products
Connecting your equipment
03
21
En
Plugging in the
receiver
After you’ve finished making all connections, plug the
receiver into an AC outlet. The type of cord and the plug
converter which can be used depends on the power
voltage in each region or country. Please make sure you
use the correct cord and plug converter due to the
possibility of fire or other hazard if used incorrectly (see
below).
Caution
• Handle the power cord by the plug part. Do not pull
out the plug by tugging the cord, and never touch the
power cord when your hands are wet, as this could
cause a short circuit or electric shock. Do not place
the unit, a piece of furniture, or other object on the
power cord or pinch the cord in any other way. Never
make a knot in the cord or tie it with other cables. The
power cords should be routed so that they are not
likely to be stepped on. A damaged power cord can
cause a fire or give you an electric shock. Check the
power cord once in a while. If you find it damaged,
ask your nearest Pioneer authorized independent
service company for a replacement.
• Do not use any power cord other than the one
supplied with this unit.
• Do not use the supplied power cord for any purpose
other than that described below.
• The receiver should be disconnected by removing the
mains plug from the wall socket when not in regular
use, e.g., when on vacation.
• Make sure the blue
STANDBY/ON
light has gone
out before unplugging.
1 Plug the supplied power cord into the AC IN
socket on the back of the receiver.
2 Plug the other end into a power outlet.
AC power cord and converter plug use
Region Plug type
For European type region
Caution
Do not use this power cord
set in Singapore and
Malaysia.
European two-pin plug
For regions with two pin flat-
bladed plug
Caution
Do not use this power cord
set in Taiwan.
European two-pin plug with two-pin
flat-bladed converter plug
For Taiwan exclusively
Caution
For use in Taiwan only. In
other areas, please do not
use.
Taiwanese two-pin flat-bladed plug
VSX_AX4AVi_G.book.fm 21 ページ ２００５年７月６日 水曜日 午後４時１２分