Pioneer VSX-91TXH Stereo System User Manual


 
6
Operations on the Receiver and Cable Connections (Continued)
2 From the receivers Manual MCACC menu, select EQ Professional then
Reverb Measurement to measure the reverb characteristics of your room.
(For details, see page 41 of the receivers Operating Instructions.)
Reverberation characteristics can also be measured with Auto MCACC but it takes longer than with
Reverb Measurement because other settings will be made prior to reverb measurement.
Note
Measurement using Auto MCACC is only available if you have selected ALL, ALL (Keep SPsetting)
or Aco Cal EQ Pro. as the Auto Mode setting.
To see the reverb characteristics of your listening area
without
the equalization performed by this
receiver (before calibration), select EQ OFF:
To see the reverb characteristics of your listening area
with
the equalization performed by this receiver
(after calibration), select ALL or ALL (Keep SPsetting) as the Auto Mode setting in the Auto MCACC
setup (see page 33 in the receivers operating instructions), then select EQ ON:
3 After measurement is complete, select Reverb Output PC in the on-screen
display.
The message Start the MCACC application on your PC appears and the receiver enters transmission
standby mode. It is ready to send data to your PC.
This completes the preparations for sending the measurement data to your PC.
(To send the data, proceed to the next section
Application Operations
.)