Filter
Top Products
8
Operations on the Receiver and Cable Connections (Continued)
2 Perform the “Auto MCACC (ALL)” operation on the receiver. (See page 8 of the
receiver’s Operating Instructions.)
The setting here is not required if the “Auto MCACC (ALL)” operation has already been performed before
connecting the RS-232C cable. Proceed to step 3.
3 From the receiver’s “Manual MCACC” menu, select “EQ Professional”, then select
“Reverb Measurement” to measure the room’s reverb characteristics.
(See page 43 of the receiver’s Operating Instructions.)
If you want to measure the room’s reverb characteristics, select “EQ OFF”, then select “Start”.
If you want to measure the room’s reverb characteristics after equalization, first perform the “Auto
MCACC (ALL)” operation, then select “EQ ON”, then “Start”. (See page 23.)
Measure the room’s reverb characteristics after equalization with the microphone at the same position as
when the “Auto MCACC (ALL)” operation was performed. The measurements are performed with the EQ
values stored in the MCACC memory selected on the receiver, so before measuring the reverb
characteristics, select the MCACC memory to be measured after equalization.
4 Select “Output PC” from “Data Management”.
The message “Start the MCACC application on your PC” appears and the receiver enters transmission
standby mode. It is ready to send data to your PC.
This completes the preparations for sending the measurement data to your PC.
(To send the data, proceed to the next section Application Operations.)
Note
MCACC : M1. MEMORY 1
Reverb Measure with
EQ OFF
[ Start ]
:Cancel
3e1. Reverb Measurement
DVD/LD
-
55.0
dB
MCACC : M1. MEMORY 1
Reverb Measure with
EQ ON
[ Start ]
:Cancel
3e1. Reverb Measurement
DVD/LD
-
55.0
dB
Start the MCACC
application on your PC.
:Cancel
5e. Output PC
DVD/LD
-
55.0
dB
:Return
5. Data Management
DVD/LD
-
55.0
dB
a. MCACC Data Check
b. Memory Rename
c. MCACC Memory Copy
d. MCACC Memory Clear
e. Output PC