Filter
Top Products
The System Setup menu08
44
En
1 Select ‘Channel Level’ from the Manual
SP Setup menu.
2 Select a setup option.
•
Manual
– Move the test tone manually
from speaker to speaker and adjust
individual channel levels.
•
Auto
– Adjust channel levels as the test
tone moves from speaker to speaker
automatically.
3 Confirm your selected setup option.
The test tones will start after you press
ENTER
.
After the volume increases to the reference
level, test tones will be output.
4 Adjust the level of each channel using
/
.
If you selected
Manual
, use
/
to switch
speakers. The
Auto
setup will output test tones
in the order shown on-screen:
Adjust the level of each speaker as the test
tone is emitted.
1
5 When you’re finished, press RETURN.
You return to the Manual SP Setup menu.
Tip
• You can change the channel levels at any
time by using
EFFECT/CH SEL
and
+/–
on
the remote control. You can set two
channel levels: one for
DVD 5.1 CH
and
one for the listening modes.
Speaker Distance
For good sound depth and separation from
your system, you need to specify the distance
of your speakers from the listening position.
The receiver can then add the proper delay
needed for effective surround sound.
1 Select ‘Speaker Distance’ from the
Manual SP Setup menu.
2 Adjust the distance of each speaker
using
/
.
You can adjust the distance of each speaker in
0.1 meter increments.
3 When you’re finished, press RETURN.
You return to the Manual SP Setup menu.
Tip
• For best surround sound, make sure the
surround back speakers are the same
distance from the listening position.
Note
1• If you are using a Sound Pressure Level (SPL) meter, take the readings from your main listening position and adjust the level
of each speaker to 75 dB SPL (C-weighting/slow reading).
• The subwoofer test tone is output at low volumes. You may need to adjust the level after testing with an actual soundtrack.
4.Manual SP Setup
:Return
a.Speaker Setting
b.Crossover Network
c.Channel Level
d.Speaker Distance
4c.Channel Level
Test Tone Manual
ENTER:Next :Cancel
4c.Channel Level
Test Tone [ Manual ]
Please Wait . . . 20
Caution!
Loud test tones
will be output.
:Cancel
4c.Channel Level
L 0.0dB
C [ 0.0dB ]
R [ 0.0dB ]
RS [ 0.0dB ]
SBR [ 0.0dB ]
SBL [ 0.0dB ]
LS [ 0.0dB ]
SW [ 0.0dB ]
:Finish
4.Manual SP Setup
:Return
a.Speaker Setting
b.Crossover Network
c.Channel Level
d.Speaker Distance
4d.Speaker Distance
L
3.0 m
C [
3.0 m ]
R [
3.0 m ]
RS [
3.0 m ]
SBR [
3.0 m ]
SBL [
3.0 m ]
LS [
3.0 m ]
SW [
3.0 m ]
:Finish
VSX_916.book.fm 44 ページ ２００５年１２月２２日 木曜日 午後４時２１分