Filter
Top Products
Connecting your equipment 03
19
En
English
Français
Deutsch
Nederlands
Italiano
Español
Bare wire connections
A-Speaker terminals:
1 Twist exposed wire strands together.
2 Loosen terminal and insert exposed wire.
3 Tighten terminal.
B-Speaker terminals:
1 Twist exposed wire strands together.
2 Push open the tabs and insert exposed
wire.
3 Release the tabs.
CAUTION
• These speaker terminals carry
HAZARDOUS LIVE voltage. To prevent
the risk of electric shock when connecting
or disconnecting the speaker cables,
disconnect the power cord before touching
any uninsulated parts.
• Make sure that all the bare speaker wire is
twisted together and inserted fully into the
speaker terminal. If any of the bare speaker
wire touches the back panel it may cause
the power to cut off as a safety measure.
Connect the surround back or front
height speakers
Connect the PRE OUT outputs of the unit and
additional amplifier to add a surround back or
front height speaker.
• If the surround back speaker or the front
height speaker is connected, set the Pre
Out setting (see The Pre Out Setting on
page 47).
• You can use the additional amplifier on the
surround back channel pre-outs for a
single speaker as well. In this case plug the
amplifier into the left (L (Single)) terminal
only.
123
10 mm
(
3
/8 in.)
12 3
10 mm
(
3
/8 in.)
IN BD
SURR BACK /
FRONT
HEIGHT
L
(
Single
)
R
R
L
IN
R
L
IN
IN
OUT
IN
CD
TV/SAT
DVD BD
DVR/VCR
M
ANTENNA
CD-R/TAPE
DVR/VCR
CD-R/TAPE
PRE OUT
DVD
TV/SAT
COAXIAL
OPTICAL
(
CD
)
IN
ASSIGNABLE
ASSIGNABLE
OUT
HDMI
DVR/VCR
1
(
CD-R/TAPE
)
IN
AUDIO
SIRIUS
IN
FM
UNBAL
75
AM
LOOP
ADAPTER
(
OUTPUT 5 V 1
1
1 2
IN
2
SUBWOOFER
PRE OUT
INPUT
LR
ANALOG
SBL/FHL SBR/FHR
Surround back or
front height speakers
Surround back or
front height
channel amplifier
VSX-820_UCSMXCN_En.book 19 ページ ２０１０年４月１２日 月曜日 午後５時１９分