Filter
Top Products
Additional information 12
69
En
English
Français
Deutsch
Nederlands
Italiano
Español
Resetting the main unit
Use this procedure to reset all the receiver’s
settings to the factory default. Use the front
panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the BAND button,
press and hold the STANDBY/ON button
for about two seconds.
3 When you see RESET? appear in the
display, press ‘
AUTO SURROUND/STREAM
DIRECT
’.
OK? shows in the display.
4 Press ‘
STEREO/A.L.C.
’ to confirm.
OK appears in the display to indicate that the
receiver has been reset to the factory settings.
Specifications
Amplifier section
Continuous average power output of 80
watts* per channel, min., at 8 ohms, from
20 Hz to 20 000 Hz with no more than
0.2 %** total harmonic distortion.
Front (stereo) . . . . . . . . . . . . . . . .80 W + 80 W
Power output (1 kHz, 8 Ω, 0.05 %)
. . . . . . . . . . . . . . . . . . . . . . . . . 110 W per channel
Guaranteed speaker impedance
FRONT:A, B . . . . . . . . . . . . . . . . . . 6 Ω to 16 Ω
FRONT:A+B. . . . . . . . . . . . . . . . . 12 Ω to 16 Ω
SURROUND, CENTER . . . . . . . . . 6 Ω to 16 Ω
* Measured pursuant to the Federal Trade Commission’s
Trade Regulation rule on Power Output Claims for
Amplifiers
** Measured by Audio Spectrum Analyzer
Audio Section
Input (Sensitivity/Impedance)
LINE . . . . . . . . . . . . . . . . . . . . . . 200 mV/47 kΩ
Output (Level/Impedance)
REC. . . . . . . . . . . . . . . . . . . . . . . 200 mV/330 Ω
ZONE 2 . . . . . . . . . . . . . . . . . . . . . 200 mV/1 kΩ
Signal-to-Noise Ratio
(IHF, short circuited, A network)
LINE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 98 dB
Signal-to-Noise Ratio [EIA, at 1 W (1 kHz)]
LINE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 79 dB
Tuner Section
Frequency Range (FM). . . 87.5 MHz to 108 MHz
Antenna Input (FM) . . . . . . . . . 75 Ω unbalanced
Frequency Range (AM) . . . 530 kHz to 1700 kHz
Antenna (AM) . . . . . . . . . . . . . . . . . Loop antenna
Video Section
Signal level
Composite. . . . . . . . . . . . . . . . . . 1 Vp-p (75 Ω)
Component Video. . . . . . . . . Y: 1.0 Vp-p (75 Ω)
PB, PR: 0.7 Vp-p (75 Ω)
Corresponding maximum resolution
Component Video. . . . . . . . . . . .1080p (1125p)
Digital In/Out Section
HDMI terminal . . . . . . . . . . . . . . 19-pin (Not DVI)
HDMI output type . . . . . . . . . . . . . . . 5 V, 100 mA
USB terminal . . . . . USB2.0 Full Speed (Type A)
iPod terminal. . . . . USB, and Video (Composite)
SIRIUS antenna cable . . . . 8-pin mini DIN cable
Integrated control section
Control (IR) terminal . . . ∅ 3.5 Mini-jack (MONO)
IR signal. . . . . . . High Active (High Level : 2.0 V)
Miscellaneous
Power Requirements . . . . . . . . . AC 120 V, 60 Hz
Power Consumption. . . . . . . . . . . . . . . . . . 250 W
In standby . . . . . . . . . . . . . . . . . . . . . . . .0.65 W
Dimensions
. . . . . 420 mm (W) x 158 mm (H) x 347.7 mm (D)
16
9
/16 in. (W) x 6
1
/4 in. (H) x 13
3
/4 in. (D)
Weight (without package) 9 kg (19 lb 14 oz)
Furnished Parts
Microphone (for Auto MCACC setup). . . . . . . . .1
Remote control . . . . . . . . . . . . . . . . . . . . . . . . . .1
Dry cell batteries (AAA size IEC R03) . . . . . . 2
AM loop antenna . . . . . . . . . . . . . . . . . . . . . . . . .1
FM wire antenna. . . . . . . . . . . . . . . . . . . . . . . . . .1
iPod cable . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
These operating instructions
Note
• Specifications and the design are subject
to possible modifications without notice,
due to improvements.
VSX-819H_KU.book Page 69 Thursday, December 25, 2008 8:36 AM