Filter
Top Products
Listening to your system 05
37
En
English
Français
Deutsch
Nederlands
Italiano
Español
Using surround back channel
processing
You can set the surround back channel when
the surround back speaker is connected and
NO
is not selected for the speaker setting
(page 42).
You can have the receiver automatically use 6.1
or 7.1 decoding for 6.1 encoded sources (for
example, Dolby Digital EX or DTS-ES), or you
can choose to always use 6.1 or 7.1 decoding
(for example, with 5.1 encoded material). With
5.1 encoded sources, a surround back channel
will be generated, but the material may sound
better in the 5.1 format for which it was
originally encoded (in which case, you can
simply switch surround back channel
processing off).
• Press
RECEIVER
, then press
SB CH
repeatedly to cycle the surround back
channel options.
Each press cycles through the options as
follows:
• SB CH ON – 6.1 or 7.1 decoding is always
used (for example, a surround back
channel will be generated for 5.1 encoded
material)
• SB CH AUTO – Automatically switches to
6.1 or 7.1 decoding for 6.1 encoded sources
(for example, Dolby Digital EX or DTS-ES)
• SB CH OFF – No sound is output from the
surround back speakers
Setting the Up Mix function
In a 7.1-channel surround system with
surround speakers placed directly at the sides
of the listening position, the surround sound
of 5.1-channel sources is heard from the side.
The Up Mix function mixes the sound of the
surround speakers with the surround back
speakers so that the surround sound is heard
from diagonally to the rear as it should be.
1
• Using the Up Mix function is effective
when the speakers in the 7.1-channel
surround system are set up as
recommended in the example on page 24.
• Depending on the positions of the
speakers and the sound source, in some
cases it may not be possible to achieve
good results. In this case, set the setting to
OFF.
1 Switch the receiver into standby.
2 While holding down the
PRESET
+ on the
front panel, and hold the
STANDBY/ON
for about two seconds.
UP MIX: OFF appears and the Up Mix function
turns off. If you want to turn this function on,
perform steps 1 and 2 again.
• When set to ON, the UP MIX indicator on
the front panel lights.
INPUT SELECT
SOURCE
INPUT
TV CONTROL
RECEIVER
ZONE 2
ON/OFF
1
4
7
SB CH
S.RETRIEVER
HDD
2
5
8
PHASE
EQ
DISPLAY
SLEEP
MIDNIGHT
DVD
3
6
9
CH
CH
CH SELECT
VCR
RECEIVER
Note
1 • Set to ON regardless of this setting when playing DTS-HD signals.
• May automatically be set to OFF even when set to ON, depending on the input signal and listening mode.
?
C
SW
FL FR
SL SR
SBL SBR SBL SBR
C
SW
FL FR
SL SR
Up Mix OFF Up Mix ON
VSX-819H_KU.book Page 37 Thursday, December 25, 2008 8:36 AM