Filter
Top Products
Connecting your equipment
2
2
17
4
34
6
Connecting an iPod
This receiver has a dedicated iPod/iPhone terminal that will
allow you to control playback of audio content from your iPod
using the controls of this receiver.
Note
•
An iPod/iPhone can be connected to the receiver. For
details on supported models and versions of the respective
products, see Playing an iPod
on page 23.
Switch the receiver into standby, and then use the iPod
cable to connect your iPod to the iPod/iPhone terminal on
the front panel of this receiver.
•
For the cable connection, also refer to the operating
instructions for your iPod.
•
When connecting an iPhone to this unit, keep the iPhone
at least 20 cm away from this unit. If the iPhone is kept
closer to this unit and a telephone call is received by the
iPhone, noise may be output from this device.
•
iPod recharging occurs whenever an iPod is connected to
this unit. (Recharging is enabled only when the unit’s
power is turned on.)
•
For instructions on playing the iPod, see Playing an iPod on
page 23.
Note
•
When the ARC function is ON and the receiver is
connected to a compatible TV with an HDMI cable, and you
switch the input of the TV when the receiver’s selection is
iPod/USB input, the receiver may automatically switch to
TV. If this happens, switch the receiver's input back to the
original input, or turn OFF the ARC function (see The HDMI
Setup menu on page 33).
Connecting a USB device
It is possible to listen to two-channel audio using the USB
interface on the front of this receiver.
Switch the receiver into standby then connect your USB
device to the iPod/iPhone terminal on the front panel of this
receiver.
•
This receiver does not support a USB hub.
•
For instructions on playing the USB device, see Playing a
USB device on page 24.
iPod/iPhone
USB cable that comes
with the iPod
This receiver
USB mass
storage device
This receiver
VSX-523_UCSMXCN_En_New.book 17 ページ ２０１２年１２月１２日 水曜日 午後３時７分