Filter
Top Products
Controls and displays 04
27
En
English
Français
Español
TEST TONE
Outputs the test tones on each channel.
Use the / buttons to select the channel
and use the / buttons to adjust the
level on each channel. Pressing TEST
TONE again exits the test tone mode.
CH SELECT
Press repeatedly to select a channel, then
use +/– to adjust the level (page 36).
CH SELECT +/–
Use to adjust the channel levels.
SPEAKERS
Use to change the speaker system on or off
(page 34).
SLEEP
Press to change the amount of time
beforethe receiver switches into standby
(30 min – 60 min – 90 min – Off). You can
check the remaining sleep time at any time
by pressing SLEEP once.
DIMMER
Dims or brightens the display. The
brightness can be controlled in four steps.
12 SOURCE
Turns on or off the power of the Pioneer DV
D/
DV
R units when BD or DVR is selected using
the MULTI CONTROL buttons.
13 TV CONTROL buttons
These buttons can control only be used with
Pioneer flat panel TVs.
Use to turn on/off the power of the TV.
INPUT
Use to select the TV input signal.
CH +/–
Use to select channels.
VOL +/–
Use to adjust the volume on your TV.
14 MASTER VOLUME +/–
Use to set the listening volume.
15 MUTE
Mutes/unmutes the sound.
16 DISPLAY
Switches the display of this unit. The input
name, listening mode or sound volume can be
checked by selecting an input source.
17
SHIFT
Press to access the ‘boxed’ commands (above
the buttons) on the remote. These buttons are
marked with an asterisk (* ) in this section.
This button is also used for operating ZONE 2
(page 39).
VSX_519V_KU.book Page 27 Wednesday, December 24, 2008 4:38 PM