Pioneer VSX-1017AV-S Stereo Receiver User Manual


 
Connecting your equipment
03
12
En
10 Multichannel pre-amplifier outputs
Use to connect separate amplifiers for front, center,
surround, surround back and subwoofer channels.
Connecting additional amplifiers on page 49 (see also
Installing your speaker system on page 18 for powered
subwoofer connection).
11 Composite and S-video monitor outputs
Use to connect monitors and TVs.
Connecting your TV and DVD player on page 13.
12 Multichannel analog audio inputs
7.1 channel inputs for connection to a DVD player with
multichannel analog outputs.
Connecting the multichannel analog inputs on
page 47.
13 Speaker terminals
Use for connection to the main front, center, surround
and surround back speakers.
Installing your speaker system on page 18.
When making cable connections
To avoid hum, do not lay connected cables over the
top of the receiver.
When connecting optical cables, be careful when
inserting the plug not to damage the shutter
protecting the optical socket.
When storing optical cable, coil loosely. The cable
may be damaged if bent around sharp corners.
About the video converter
When the video converter is enabled, all analog video
sources are output through all of the MONITOR VIDEO
OUT jacks (HDMI and component video cannot be
converted).
1
See Video Converter Setup on page 54 to
switch the video converter on or off.
If several video components are assigned to the same
input function (see The Input Assign menu on page 52),
the converter gives priority to component, S-video, then
composite (in that order).
For optimal video performance, THX recommends
switching video conversion (in Video Converter Setup
on page 54) OFF.
Note
1 You must connect your monitor/TV to the receiver’s HDMI/component video outputs when connecting these video sources. If the video signal does not
appear on your TV or plasma display, try adjusting the resolution settings on your component or display. Note that some components (such as video game
units) have resolutions that may not be converted. In this case, use an (analog) S-video or composite connection.
This product incorporates copyright protection technology
that is protected by U.S. patents and other intellectual
property rights. Use of this copyright protection
technology must be authorized by Macrovision
Corporation, and is intended for home and other limited
consumer uses only unless otherwise authorized by
Macrovision. Reverse engineering or disassembly is
prohibited.
VSX-1017_HY.book Page 12 Tuesday, March 6, 2007 3:53 PM