Filter
Top Products
44
En
Additional Information12
Resetting the system
Resetting the system returns all menu, picture and
password settings to their factory defaults.
1 Switch the system into standby using the
front panel standby/on switch.
2 Hold down the front panel 7 button and
switch back on.
Switching the AM frequency interval
As its default setting, the tuner jumps in steps of 10kHz
when tuning in AM stations. If you find that this is
unsuitable in your area (if you can’t tune into stations
successfully), you can change the tuning interval to
9kHz for AM. Here’s how to switch the setting.
1 Switch the system into standby.
2 Press SYSTEM SETUP.
3 Press the 2 or 3 button until you see AM
STEP in the display.
4 Use the 5 and ∞ buttons to select 9kHz
or 10kHz.
• When set to 9kHz, the FM tuning interval becomes
50kHz.
5 Press ENTER.
Setting the display brightness
You can adjust the brightness of the display to suit the
lighting conditions of the room.
• Press FL DIMMER (SHIFT & >10).
Press repeatedly to set the display brightness. There are
five levels.
Switching the time format
You can display the clock in either 12 or 24-hour
format.
1 Switch the system into standby.
2 Press SYSTEM SETUP.
3 Press the 2 or 3 button until you see
CLOCK 12 HR or CLOCK 24 HR in the
display.
4 Use the 5 and ∞ buttons to select 12 or
24.
5 Press ENTER.