Filter
Top Products
16
En
Setting Up4
Switching on and setting the clock
This system has a built-in clock, which needs to be set
to be able to use the timer features.
STANDBY
/ON
ENTER
SYSTEM SETUP
3
5
∞
2
SYSTEM DISP
1 Press to switch on.
2 Press SYSTEM SETUP.
3 Press the 2 or 3 button until you see
TIMER in the display.
4 Press ENTER.
5 Press 2 or 3 until you see CLOCK ADJ in
the display.
6 Press ENTER.
The display shows a clock, with the hour blinking.
7 Use the 5 and ∞ buttons to set the hour,
then press ENTER.
8 Use the 5 and ∞ buttons to set the
minute, then press ENTER.
The display blinks to indicate that the time has been set.
• Press SYSTEM DISP anytime to see the clock when
the system is on or in standby.
Setting up for surround sound
You can use this system right out of the box for
surround sound with just the default settings. However,
for really great surround sound, we recommend that
you spend a few minutes making some settings that
match this system to your listening room. Unless you
change the layout of your speakers or main listening
position, you only need to make most of these settings
once.
TEST TONE
/CH LEVEL
SURROUND
MODE
ENTER
SYSTEM SETUP
3
5
∞
2
VOLUME
–+
SHIFT
Setting the speaker distances
1 Press SYSTEM SETUP.
2 Press the 2 or 3 button until you see
FRT. SP in the display.
3 Use the 5 and ∞ buttons to set the
distance from your main listening posi-
tion to the front speakers.
Ideally, your listening position should be equidistant
from the two front speakers.
The default setting is 3m. You can adjust the range
from 0.3m to 9.0m in steps of 0.3m.