Filter
Top Products
Connecting the Power Terminal
• Always use the recommended battery and ground
wire, which is sold separately. Connect the battery
wire directly to the car battery positive terminal
(+) and the ground wire to the car body.
• Recommended wires size (AWG: American Wire
Gauge) is as follows. The battery wire, the ground
wire and the optional direct ground wire must be
same size.
• Use a 10 AWG to 20 AWG wire for the system
remote control wire.
Battery Wire and Ground Wire Size
Wire Length less than 3.6 m less than 6.4 m
Wire Size 6 AWG 4 AWG
1. Pass the battery wire from the
engine compartment to the interior
of the vehicle.
• After making all other connections to the
amplifier, connect the battery wire terminal
of the amplifier to the positive (+) terminal of
the battery.
2. Expose the end of wires using nip-
pers or a cutter.
• Battery wire, ground wire: 18 mm to 20 mm
•
System remote control wire: 14 mm to 16 mm
3. Connect the wires to the terminal.
• Fix the wires securely with the terminal
screws.
WARNING
Failure to securely fasten the battery wire to the ter-
minal using the terminal screws could cause the ter-
minal area to overheat and could result in damage
and injury including minor burns.
4. Put the wire ties in the slits and
wrap the wire ties around the wires.
• Wrap the wire tie around the wire insulation,
not the stripped wire.
• Cut off any excess portions of the wire ties.
9
Connecting the Unit
Wire tie
Engine
compartment
Interior of
the vehicle
Drill a 14
mm hole into
the vehicle
body.
Insert the O-ring rubber
grommet into the vehicle
body.
Positive (+)
terminal
Fuse 200 A
Each amplifier must
be SEPARATELY
fused at 200 A.
The maximum length of the wire
between the fuse and the positive (+)
terminal of the battery is 45 cm.
GND
terminal
System remote
control terminal
Terminal
screw
Ground wire
System remote
control wire
Battery wire
Power terminal