15
ENG/MASTER 96
<YRD5194B> 16
Installation
Attaching the bass boost remote
control
Attach with tapping screws (3 mm × 10 mm) at an
easily accessible location such as under the dash-
board.
Example of installation on the floor
mat or on the chassis
1. Place the amplifier where it is to be
installed. Insert the supplied tap-
ping screws (4 mm × 30 mm) into
the screw holes. Push on the screws
with a screwdriver so they make
marks where the installation holes
are to be located.
2. Drill 2.5 mm (1/8 inch) diameter
holes at the point marked, and
install the amplifier, either on the
carpet or directly to the chassis.
Replacing the top cover
1. Align the unit and top cover, and
insert the screw.
• The cover can be installed in the desired
direction to match to the amplifier.
2. Tighten the screw with a 4 mm
hexagonal wrench.
Drill a 2.5 mm (1/8 inch)
diameter hole
Tapping-screws
(4 mm × 30 mm)
Floor mat
or chassis
Screw
Top Cover
Tapping screw
(3 mm × 10 mm)
1_YRD5194B_Eng 2009.11.12 1:43 PM Page 16