Filter
Top Products
I Programming a pause
Inserting a pause in your program can be very useful when carrying
out recording. Press II instead of entering a track number. "PA"
appears on the display panel.
• For example, when recording on both sides of a cassette tape,
if you p_ogram a pause after the last track to be recorded on
the first side, program playback will pause at that point to allow
you to switch tape sides. To resume program playback after the
player enters pause mode, press II.
Notes:
s A pause can be programmed only when the program pn_cedure
is performed under stop mode.
• A pause cannot be programmed at the beginning of a program
(P-01), and two pauses cannot be programmed one after the
other.
• A pause inserted in a program is counted as one step.
• If a pause [s programmed as the last step of a program, the
player will not enter the pause mode.
I To clear all of the program contents -_
®
SlOP
CC]
®
D
(_) During stop mode, press e.
® When the magazine is ejected, the program contents will be
cleared.
I To erase a program (PD-M550/PD-M455/PD-
M453 only)
CLEAR CLEAR
F-7 ,_ ECI
During program mode, press CLEAR on the remote control unit.
The last program step is erased and the contents of the previous
program step are displayed.
NOTE:
Contents of a program can be erased during playback as well.
However, tracks preceding the currently playing track cannot be
erased in this way.
TO PLAY ONLY DESIRED TRACKS/DISCS
i
I [
To checkithe program contents (PD-M550/
PD-M455/PD-M453 only)
I
gp
CHECK
"[ -.... I
i-u9 P- £1
"_ @ @ @@
I@ ..... I
3-D'V P- 0_
" @ @ @@
i
During program mode, set the ptayer to stop mode and press
CHECK. The prpgram contents will be displayed in the programmed
order,
• After confi_fming the last program step, the display will show
"O-O0"
,,,,i
I To modi_ithe program contents (PD-M550/PD-
M455/PD-M453 only)
1,
2.
PD-M550
,_ @ @ @ @
5 7
DISC TRACK
NUMBER NUMBER
PD-M455/pDiM453
..,.o 'Aac"-,r
TRACK
-"- P- 2 t
....
During program mode, set the player to stop mode and press
CHECK so that the program step to be corrected appears on
the display,
To correct th
NUMBER bu
the TRACK I
dPress
isplay. For
No. 3 is cha
DISC NUMB
M550), or I_
Repeat steps
For PD-M55C
the track No
PGM
disc NO., enter the new disc No. with the DISC
tons. For PD-M550, enter the new track No. with
JUMBER/Digit buttons. For PD-M45B/PD-M453,
_1so that the the new disc No, appears on the
)xample.: the programmed track No. 4 on the disc
iged to track No. 7 on the disc No, 5, using the
-_R5 button and TRACK NUMBER 7 button (PD-
I/1_ and PROGRAM (PD-M455/PD-M453).
1 and 2 to change other tracks as desired.
the _ or _ button can also be used to correct
After selecting the track No., be sure to press
15
<PRB1142>
En