Filter
Top Products
Getting started04
12
En
Chapter 4
Getting started
Switching on
After making sure that everything is connected
properly and that the player is plugged in, push
the POWER button into the
ON
position to
switch the player on.
• Press on the remote to switch the unit
into standby.
Playing discs
The basic playback controls for playing CDs,
SACDs, and MP3/WMA discs are covered
here. Further functions are detailed in Other
playback features on page 13.
1 If the player isn’t already on, press
POWER
to switch it on.
2Press
(OPEN/CLOSE) to open the disc
tray.
3 Load a disc.
Load a disc with the label side facing up, using
the disc tray guide to align the disc. Once
properly seated, press to close the disc tray.
4 Press
(play) to start playback.
Basic playback controls
The table below shows the basic controls for
playing discs.
ONOFF
POWER
STANDBY
PURE AUDIO
POWER OFF ON
DIMMER
ENTER
1
23
456
7890
PROGRAM REPEAT RANDOM TIME
OPEN/CLOSE
PURE AUDIO
CLEAR
Button What it does
Starts playback.
Pauses a disc that’s playing, or
restarts a paused disc.
/ (front
panel only)
Starts playback/stops a disc that’s
playing.
• While depressing /, press
(front panel only). Counting from the
first track on the disc, playback will
begin from the track number
corresponding to the number of
times is pressed.
Stops playback.
Press to start fast reverse scanning.
Press
(play) to resume normal
playback.
Press to start fast forward scanning.
Press
(play) to resume normal
playback.
Skips to the start of the current
track, then to previous tracks.
PD-D6-J_MY.book Page 12 Friday, September 8, 2006 4:25 PM