Filter
Top Products
&RQQHFWLQJWKH 8QLWV
Connection in a car featuring an ISO Connector
You can connect the car stereo power cord as it is.
(Do not use the power cord supplied with this unit.)
Attention:
The connector wiring may vary depending on the car manufacturer, even when ISO connectors
are used. We recommend to check the car’s wiring provision before connecting the car stereo.
Please pay particular attention to pin 5, where a misconnection might cause damage to the car or
radio.
Take special care when installing into ’98 or later VW/Audi/Skoda/Seat models as there may be
a 12 V connection on Pin 5, which could damage the car stereo or into Ford from ’97 or later,
with an ISO connector, on which damage to the car’s microcomputers is possible if
misconnected. Use of ISO connector adapters available on the market may facilitate installation.
Refer to "Connection in a car not featuring an ISO Connector."
Accessory
To electric terminal controlled by ignition
switch (12 V DC)
ON/OFF.
Back-up
To terminal always supplied
with power regardless of
ignition switch position.
Switch
Car stereo power cord.