Filter
Top Products
Getting started02
10
En
Chapter 2
Getting started
Home theater sound setup
Place your speakers as shown below for
optimal surround sound (see the Speaker
Setup Guide for more placement tips).
• Standard surround setup – This is a
standard multichannel surround sound
speaker setup for optimal 5.1 channel
home theater sound.
Depending on the size and characteristics of
your room, you can choose to use the following
setup option:
1
• Front surround setup – This setup is ideal
when rear surround speaker placement
isn't possible or you want to avoid running
long speaker cables in your listening area.
The placement of speakers shown below
allows for the creation of virtual surround
sound.
For HTZ363DVD:
For HTZ565DVD and HTZ767DVD:
After placing your speakers, see Using the
Auto MCACC setup for optimal surround sound
below to complete your surround setup.
Using the Auto MCACC setup for
optimal surround sound
The Multichannel Acoustic Calibration
(MCACC) system measures the acoustic
characteristics of your listening area, taking
into account ambient noise and testing for
channel delay and channel level. After you
have set up the microphone provided with your
system, the receiver uses the information from
a series of test tones to optimize the speaker
settings and equalization (Acoustic Calibration
EQ) for your particular room.
2
Important
• These test tones are loud; however, do not
turn the volume down during setup as this
may result in a sub-optimal calibration.
Note
1See Using Front Stage Surround Advance on page 16 to select a front surround mode when using this setup.
Front left
Surround
left
Listening position
Center
Subwoofer
Front right
Surround
right
Front
left
Front
right
Surround
left
Surround
right
Listening position
Center
Subwoofer
2 You only need to use the Auto MCACC setup once (unless you change the placement of your speakers or your room layout).
Front
left
Front
right
Surround
left
Surround
right
Listening position
Center
Subwoofer
HTZ363DVD_EN_WL.book 10 ページ ２００７年２月３日 土曜日 午後３時１３分