Pioneer HTZ565DVD Home Theater System User Manual


 
Other connections 09
37
En
English
FrançaisDeutsch
Nederlands
Italiano Español
4 Assign any input source connected to the
plasma television to the corresponding input
number.
Use / to select the source (DVD, LN
(LINE) or USB), then / to select the input
number.
This matches this unit’s input source with a
numbered video input on the plasma
television.
1
For example, select the LN PDP3
setting if the video output of your line
component is connected to video input 3 on
the plasma television. TVTN switches the
plasma television to its built-in tuner and
NONE leaves the plasma television input as is
(no switching takes place).
5 When you're finished, press
ENTER
.
Switching on the SR+ mode
1
Press
SHIFT+SR+
on the remote.
2Use / to select SR+ ON then press
ENTER.
To switch SR+ control off, select SR+ OFF.
If you disconnect the SR+ cable or switch
the plasma television off while SR+ is on,
the SR+ ON setting remains.
The SR+ setting is maintained even after
switching this system into standby then
back on. Automatic muting will be effective
when this system is switched on.
About control out connections
Many Pioneer components support SR
CONTROL connections, by which you can use
the remote controls of any connected
components by aiming them at the sensor of
just one component. When you use a remote
control, the control signal is passed along the
chain to the appropriate component. This can
be useful when you have multiple components
contained inside an entertainment center.
If you choose to use this feature, you must
make sure that you also have at least one set of
analog audio jacks connected to another
component for grounding purposes.
Using a cable with mono mini-plugs on
either side (sold separately), connect the
CONTROL IN jack on another Pioneer
component to the CONTROL OUT jack on this
unit.
This will allow you to control the other
component by pointing its remote at this unit.
When this unit is connected to both another
device and a plasma television, you can control
all components by pointing their respective
remote controls at the sensor for the plasma
television.
Note
1The PDP5 input may be called ‘PC Input’ (or similar) on your plasma television.
HTZ363DVD_EN_WL.book 37 ページ 2007年2月3日 土曜日 午後3時13分