Filter
Top Products
Additional information10
46
En
Error Messages
No HDMI video output • Make sure that you’ve selected this player as the HDMI input in the settings for
the component you’re using (refer to the component’s instruction manual).
• Check that the HDMI cable is connected properly and isn’t damaged.
• Check that components connected using the HDMI interface are switched on
and HDMI compatible (Components must be compatible with both DVI and High
Bandwidth Digital Content Protection (HDCP)).
• Depending on the component you have connected, using a DVI connection may
result in unreliable signal transfers.
• Make sure the resolution on this player matches that of the component you have
connected using HDMI. See Video Output settings on page 29 to change the HDMI
resolution.
• If the screen goes blank after changing the resolution, it means the you selected
a resolution incompatible with your monitor. See Resetting the HDMI connection
on page 36 to reset to the factory defaults.
Color problems occur
with your monitor after
changing the
HDMI
Color
setting (page 30).
• Depending on the connected equipment, some HDMI Color settings may cause
the picture to be displayed incorrectly. In this case, use the TV’s own video input
settings to select RGB, if possible. Alternatively, revert to the previous HDMI Color
setting.
Problem Remedy
Message Description
EXTRAPWR • You cannot adjust SFC modes, tone controls (bass, treble, and bass boost),
MP3 Expander mode, Voice Enhancer mode when using Extra Power mode.
SND.DEMO • The sound demo is on. See General in Troubleshooting on page 43.
CANNOT • An operation is prohibited because DVD/CD or USB isn’t selected, headphones
are connected, or SHIFT+TEST TONE is pressed during disc playback.
MUTING • An operation is prohibited because the sound is muted (press MUTE).
STEREO • An operation is prohibited because the DVD/CD or USB function isn’t selected.
TRAYLOCK • The tray lock is on. See General in Troubleshooting on page 43.
KEYLOCK • The key lock is enabled. See Setting the Key Lock below.
USB ERR • See Important in Using the USB interface on page 25 for more on this.
HDMI ERR • See HDMI connection above for troubleshooting tips. See also Resetting the
HDMI connection on page 36 if the problem persists.
EEP ERR • Contact your Pioneer authorized service center or your dealer for servicing.
EXIT • Appears when any prohibited signal is input or the headphones are connected
while the menu screen is displayed, and then the display returns to the normal
display.
NO MIC
• Appears when you press SHIFT+KARAOKE, SHIFT+ECHO, SHIFT+ or SHIFT+
when no mic is inserted.
MIC IN • Appears when you press SURROUND, SOUND, FRT. SURR/EXT PWR or MP3
EXP/V.ENH when a mic is inserted.
HTZ170_171_270_272_En.book 46 ページ ２００８年２月２８日 木曜日 午後１時２４分