Filter
Top Products
# When a subwoofer is connected to the rear
output, set for subwoofer R-SP:S/W.
# When the rear output setting is R-SP:S/W,
you cannot change the subwoofer controller.
Notes
! Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer toUsing subwoofer output on page
31).
! If you change this setting, subwoofer output
in the audio menu return to the factory set-
tings.
! Both rear speakerleads outputsand RCA rear
output are switchedsimultaneously in this
setting.
Turning the clock display
on or off
You can turn the clock display on or off.
% Press CLOCK to turn the clock display
on or off.
Each press of CLOCK turns the clock display
on or off.
# The clock display disappears temporarily
when you perform otheroperations, but the clock
display appears again after 25seconds.
Note
Even when the sources are off, the clock display
appears on the display. Pressing CLOCK turns
the clock display on or off.
Using the AUX source
This unit can control up to two auxiliary equip-
ments such as VCR or portable devices (sold
separately). When connected, auxiliary equip-
ments are automatically read in as AUX
sources and assigned to AUX1 or AUX2. The
relationship between AUX1 and AUX2
sources is explained below.
About AUX connection method
You have two methods to connect auxiliary
equipments to this unit.
Stereo mini pin plug cable (AUX1)
When connecting auxiliary equipment using a
stereo mini plug cable
% Insert the stereo mini plug into the
AUX input jack on this unit.
IP-BUS-RCA interconnector (AUX2)
When connecting auxiliary equipment using an
IP-BUS-RCA Interconnector (sold separately)
% Use an IP-BUS-RCA Interconnector such
as the CD-RB20/CD-RB10 (sold separetely)
to connect this unit to auxiliary equipment
featuring RCA output.
For more details, refer to the IP-BUS-RCA Inter-
connector owner’s manual.
# You can only make this type of connection if
the auxiliary equipment has RCA outputs.
Selecting AUX as the source
Auxiliary equipments connected to this unit
can be activated or deactivated individually.
% Press SOURCE to select AUX (AUX1 or
AUX2) as the source.
Press SOURCE until AUX appears in the dis-
play.
# If the auxiliary setting is notturned on, AUX