Pioneer CT-F10 Stereo Amplifier User Manual


 
36
9
Additional Information
Switching the auxiliary
attenuator on/off
Depending on the component that you connect to the
auxiliary inputs, it’s possible that the signal level will be too
high for this system to play properly without the sound
distorting. If you notice distortion when listening to the
auxiliary component, try switching the attenuator on.
1 Switch the unit into standby.
2 Press SYSTEM MENU and select AUX ATT.
Remember: switch between menu options using 4 and
¢; select the option by pressing SET.
3 Use 4 or ¢ to select ATT ON or ATT OFF
as required.
The default setting is ATT OFF (attenuate off).
4 Press SET.
The system goes back into standby.
If you selected ATT ON, the level of the input signal is
reduced to prevent distortion.
Setting the display
brightness
You can adjust the brightness of the display to suit the
lighting conditions of the room. For example, in a brightly lit
room you'd probably want the display brighter than in a room
with low lighting.
1 Press SYSTEM MENU and select DIMMER SEL.
Remember: switch between menu options using 4 and
¢; select the option by pressing SET.
2 Adjust the brightness using the 4 and ¢
buttons.
There are five levels of brightness (UK model default is 4; non-
UK model default is 5).
3 Press SET.
The system goes back into standby.
When switched on, the blue light on the disc compartment
door and on the front of the tape deck changes (3 levels)
with the display brightness.
Switching the door open
sensor on/off
The door open sensor on the front of the CD tuner has two
operating modes, as well as an off setting.
1 Switch the unit into standby.
2 Press SYSTEM MENU and select SENSOR
MODE.
Remember: switch between menu options using 4 and
¢; select the option by pressing SET.
3 Use 4 or ¢ to select MODE 1, MODE 2
or OFF as required.
SNSR MODE 1 – (default) the door will open
automatically, even if a disc is currently playing.
SNSR MODE 2 – the door will only open automati-
cally if no disc is playing.
SNSR OFF – switches off the automatic door feature
4 Press SET.
The system goes back into standby.
Switching the open/close
beep on/off
By default, when you press OPEN/CLOSE to open or close
the disc compartment, you’ll hear a beep. If you would prefer
not to, here’s how to switch it off:
1 Switch the unit into standby.
2 Press SYSTEM MENU and select BEEP MODE.
Remember: switch between menu options using 4 and
¢; select the option by pressing SET.
3 Use 4 or ¢ to select BEEP ON or BEEP
OFF as required.
4 Press SET.
The system goes back into standby.